We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three galvanized steel tool holders with curved hooks

National Manufacturing Co.

National Manufacturing Co. N180-539 3 Pack 3/4" Single Tool Holder Galvanized Steel

SKU CH-ARM4-B5D3E

Holds tools on 1/8″ or 1/4″ perforated board with three galvanised steel holders

  • Galvanised steel resists corrosion for long garage life
  • Three holders organise multiple tools in one purchase
  • Fits 1/8″ and 1/4″ perforated board for versatile mounting
  • Carded packaging keeps each holder protected until use

National Manufacturing Co. N180-539 Tool Holder Pack

This three-pack of galvanized steel holders fits 3/4-inch tools securely. Each unit mounts on standard 1/8-inch or 1/4-inch perforated board for versatile garage organisation. The carded packaging keeps the set tidy until installation.

Galvanized Steel Wall Storage for Hand Tools

Passive steel construction produces no heat, noise or power draw during use. The galvanized finish resists corrosion in humid workshop environments. Load capacity depends on the mounting board and fastener strength.

Highlights

  • Galvanised steel resists corrosion for long garage life
  • Three holders organise multiple tools in one purchase
  • Fits 1/8″ and 1/4″ perforated board for versatile mounting
  • Carded packaging keeps each holder protected until use

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the N180-539 tool holders on my perforated board?

Mount the holder onto a 1/8" or 1/4" perforated board by inserting the prongs into the holes and pressing firmly until seated; the common mistake is not fully engaging both prongs, which lets the holder rotate under load.

Will the galvanized coating on these holders need any upkeep over time?

The galvanized steel resists rust without maintenance; if the coating is scratched, wipe the area clean and apply a cold-galvanizing spray to restore protection.

More in Tool Storage

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.