We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

N a S C O

N a S C O 1801JN110 Flame Resistant Rain Jacket 16 cal/sq cm XL 5 oz Kevlar personal protective equipment

SKU CH-XWA8-Y0MXX

Flame-resistant rain jacket rated at 16 cal/sq cm with packable hood, non-conductive zipper and fall-protection access

  • Flame-resistant protection rated at 16 cal/sq cm ATPV
  • Arc-rated PPE Category 2 for electrical hazard defence
  • Non-conductive zipper closure eliminates metal ignition risk
  • Packable hood in collar deploys quickly in wet conditions
  • Fall-protection access on back supports harness compatibility

Flame Resistant Rain Jacket 16 cal/sq cm

This flame resistant rain jacket carries an ATPV rating of 16 cal/sq cm and meets ANSI Class 3 with Arc Flash PPE Category 2. It is built for workers who need arc-rated wet-weather protection on the job.

Thermals noise and power draw in normal use

The Kevlar and Nomex fabric weighs 5 oz and uses a packable hood stored in the collar. A non-conductive zipper closes the front while the 30 in length covers the torso without adding bulk.

Fall protection access on back of jacket

A dedicated opening on the rear panel allows a fall-protection harness to be worn underneath without compromising the arc rating. The navy colour and absence of high-visibility trim suit environments where low-visibility FR gear is required.

Highlights

  • Flame-resistant protection rated at 16 cal/sq cm ATPV
  • Arc-rated PPE Category 2 for electrical hazard defence
  • Non-conductive zipper closure eliminates metal ignition risk
  • Packable hood in collar deploys quickly in wet conditions
  • Fall-protection access on back supports harness compatibility

Specifications

BrandNASCO

Questions about this item

How do I fasten the non-conductive zipper and deploy the packable hood without snagging the Kevlar Nomex fabric?

Pull the zipper slowly from the bottom stop to the top, keeping the placket flat; the hood unfolds from inside the collar — shake it once to seat the brim before zipping the storm flap over it.

When should I retire the jacket based on the 16 cal/sq cm ATPV rating and Kevlar Nomex liner condition?

Remove it from service once the outer shell shows abrasion through the 5 oz fabric, any seam tape lifts, or the liner feels thin or stiff — each defect cuts the 16 cal/sq cm protection.

At what point does the 5 oz Kevlar Nomex shell become the limiting factor during extended arc exposure?

The 16 cal/sq cm ATPV is the first ceiling; sustained heat above that level will break down the 5 oz fabric and liner faster than the 30 in length or 48 to 50 in chest range can compensate.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.