Mirka
Mirka 913GV Backup Pad 3 Inch Multi-Hole Grip
A 3-inch multi-hole grip backup pad with medium-density foam and 1/4-20 threaded attachment for handheld disc sanders
- TypeHandheld Disc Sanders
- 3-inch multi-hole design improves dust extraction
- Medium-density foam backing delivers consistent finishing results
- Grip-faced surface holds abrasive discs securely
- 1/4 x 20 threaded attachment fits compatible tools directly
- Molded polymer construction resists wear during heavy use
3-Inch Multi-Hole Backup Pad
The Mirka 913GV is a medium-density foam backing pad designed for handheld disc sanders. Its three-inch diameter and multi-hole pattern work with vacuum extraction to keep the surface clear while you sand. The grip-faced surface holds hook-and-loop abrasives securely during use. A 1/4-20 threaded attachment fits compatible pneumatic or hydraulic tools.
Replaces Worn or Single-Hole Pads
Swap this in when an existing pad has lost grip, cracked, or clogs quickly with dust. The multi-hole layout improves extraction over single-hole designs, so the upgrade is worth it when dust buildup slows the job or finishes show swirl marks. It fits the same 1/4-20 thread as the original equipment on many Mirka sanders.
Consistent Contact Under Load
Medium-density foam keeps the abrasive flat against curves and edges during extended sanding sessions. The vacuum holes maintain suction even when the pad flexes, preventing heat buildup that can soften the backing. Grip face adhesion stays reliable through repeated disc changes without the pad surface glazing over.
Highlights
- 3-inch multi-hole design improves dust extraction
- Medium-density foam backing delivers consistent finishing results
- Grip-faced surface holds abrasive discs securely
- 1/4 x 20 threaded attachment fits compatible tools directly
- Molded polymer construction resists wear during heavy use
Specifications
| Type | Handheld Disc Sanders |
|---|---|
| Brand | Mirka |
Questions about this item
What thread size does the 913GV backup pad need to mount on my sander?
It uses a 1/4 x 20 threaded attachment for direct mounting on compatible handheld disc sanders.
How do I attach the 913GV pad to my tool without damaging the threads?
Align the 1/4 x 20 threads carefully and hand-tighten until snug; avoid cross-threading by not forcing the first turns.
When should I replace the foam on my 913GV backup pad?
Replace the medium-density foam backing when it loses firmness, shows deep grooves, or no longer holds abrasive discs securely.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
