Miller Enterprises
Miller Enterprises 212730 Drag Shield 60 A for 60T 80CX TM 100T hand tool
Drag shield for 60 A plasma cutting on ICE 60T/TM, 80CX/T and 100T torches
- TypeAngle, Pitch & Slope Locators
- Compatible with 60T, 80CX, TM, 100T models
- 60 AMP rating suits plasma cutting tasks
- Drag shield protects torch tip during operation
- Miller Electric 212730 built for professional use
Drag Shield 60 A for Plasma Cutting
The Miller Enterprises 212730 Drag Shield is a plasma cutting accessory rated at 60 amps. It is designed for use with compatible ICE 60T, ICE 60TM, ICE 80CX and ICE 100T systems. This new hand tool helps maintain consistent standoff distance during cutting operations. It suits operators who need a direct replacement shield for these specific machine models.
Sustained Cutting Behaviour
During extended cutting sessions the shield protects the torch tip from molten spatter and heat buildup. Its 60 amp rating matches the output of supported ICE power sources to prevent premature wear. The design allows continuous drag cutting without frequent stoppages for tip cleaning. It is not intended for machines operating above the listed amperage or for incompatible torch configurations.
Highlights
- Compatible with 60T, 80CX, TM, 100T models
- 60 AMP rating suits plasma cutting tasks
- Drag shield protects torch tip during operation
- Miller Electric 212730 built for professional use
Specifications
| Brand | MILLER ELECTRIC |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
Does the 212730 drag shield get hot during extended plasma cutting at 60 A?
The drag shield is built for 60 A plasma cutting and will become hot during continuous use; allow it to cool between long cuts.
Which plasma cutter models must I already own for the 212730 drag shield to fit?
It fits Miller ICE 60T, ICE 60TM, ICE 80CX, ICE 80T and ICE 100T plasma cutters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
