Miller Enterprises
Miller Enterprises 198127 XR-Pistol Push-Pull MIG Gun 15 ft 200 A 100% Duty Cycle 0.063 in Wire
Push-pull MIG gun with 15 ft cable, 200 A at 100% duty cycle, and .063 in wire capacity for aluminium welding
- TypeWelding Parts & Supplies
- Push-pull action feeds aluminum wire smoothly
- 200 A at 100 % duty cycle handles long runs
- Air-cooled design keeps weight down on the bench
- 15 ft cable reaches across the work area
- Pistol grip and hold trigger give steady control
Miller XR-Pistol Push-Pull MIG Gun
The Miller 198127 XR-Pistol is a push-pull MIG gun built for aluminum welding. Its pistol-grip handle and hold-type trigger give the operator direct control over wire feed. The 15 ft cable suits workstations where the feeder sits at a moderate distance.
200 A at 100 % duty cycle headroom
Rated at 200 amps with a 100 percent duty cycle, the gun handles continuous aluminum MIG runs without a cooling pause. It feeds wire up to .063 in diameter using the FasTip series. The air-cooled design and argon shielding limit it to lighter-gauge aluminum; thicker plate or higher-deposition jobs will exceed its thermal capacity.
Air-cooled thermals and power draw
Air cooling keeps the gun light but means heat builds steadily during long seams. At the full 200 A rating the handle warms noticeably, so operators typically pause between extended passes. The push-pull motor adds modest electrical load on the feeder, and the argon flow rate matches standard aluminum MIG practice.
Highlights
- Push-pull action feeds aluminum wire smoothly
- 200 A at 100 % duty cycle handles long runs
- Air-cooled design keeps weight down on the bench
- 15 ft cable reaches across the work area
- Pistol grip and hold trigger give steady control
Specifications
| Brand | MILLER ELECTRIC |
|---|---|
| Type | Welding Parts & Supplies |
Questions about this item
Will the 15 ft XR-Pistol gun connect to my existing Miller-compatible rear feeder without an adapter?
Yes, the gun is built for a Miller-compatible rear connection so it plugs straight into your current feeder.
How can I confirm the 200 A gun is running at its full 100 % duty cycle during a long aluminum run?
The gun stays cool enough to weld continuously at 200 A; if the handle remains comfortable and wire feeds smoothly, you are at full duty cycle.
Does the box include a FasTip contact tip for .063 in aluminum wire, or do I need to buy one separately?
The gun uses the FasTip series; a starter tip is typically included, but verify the exact .063 in size is in the package before you start.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
