MIDWEST FASTENER CORP
MIDWEST FASTENER CORP 66525 1/4IP Zinc Plated Steel Female Air Hose Connectors 4PK
Pack of four zinc-plated steel female connectors for 1/4-inch air hose fittings
- Zinc-plated steel resists corrosion for longer service life
- 1/4-inch IP female threads fit standard air-tool connections
- Four-pack supplies spares for multiple workstations
- California Proposition 65 warning discloses listed chemicals
- Brand Midwest Fastener identifies the manufacturer
1/4-inch Female Air Hose Connectors
This four-pack of zinc-plated steel connectors fits 1/4-inch IP threads on air hoses and tools. They are designed for workshops and garages that run compressed-air systems. The steel construction resists deformation under repeated coupling cycles. Each piece is new and ready for immediate installation.
1/4-inch IP Thread Compatibility
The single specification that determines fit is the 1/4-inch IP thread size. Only hoses and fittings with matching 1/4-inch IP threads will seal correctly with these connectors. Mismatched thread standards will leak or damage the fitting. Verify the thread callout on your existing equipment before purchase.
Four-Pack Capacity for Standard Runs
The pack supplies four connectors, enough for a typical single-hose setup with a tool and a quick-change coupler. It covers one complete connection pair plus a spare for each end. Larger multi-hose manifolds or extended distribution lines will require additional packs. The zinc plating provides baseline corrosion resistance for indoor shop air.
Highlights
- Zinc-plated steel resists corrosion for longer service life
- 1/4-inch IP female threads fit standard air-tool connections
- Four-pack supplies spares for multiple workstations
- California Proposition 65 warning discloses listed chemicals
- Brand Midwest Fastener identifies the manufacturer
Specifications
| Brand | MIDWEST FASTENER |
|---|
Questions about this item
What does the 1/4IP thread size mean when I connect these to my air hose?
The 1/4IP thread matches standard 1/4-inch pipe fittings on most shop air hoses and tools, so the connectors screw on directly without adapters.
How does the zinc-plated steel construction hold up to daily compressor use?
Zinc plating resists rust from moisture in compressed air lines, and the steel body withstands repeated coupling and uncoupling under normal shop pressure.
What do I need to mount or install the four connectors in the pack?
Each connector threads onto a male 1/4IP fitting by hand or with a wrench; no brackets, clamps or special tools are required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
