MIDWEST FASTENER CORP
MIDWEST FASTENER CORP 52195 5/8" Wire Rope Clips 10PK
Pack of ten 5/8" wire rope clips for securing cable ends in lifting and pulling applications
- Pack of ten clips covers multiple rigging points
- 5/8 inch size fits standard wire rope diameters
- California Prop 65 warning alerts to chemical exposure risks
- Manufacturer-direct shipping streamlines delivery for qualifying orders
- New condition ensures full structural integrity for lifting tasks
Wire rope clips for rigging
This pack contains ten clips sized for five-eighths inch wire rope. They suit builders, maintenance crews and marine users who need reliable termination points for lifting or pulling assemblies. The clips are supplied new and ready for immediate installation on site.
Grip holds under continuous tension
Each clip uses a forged saddle and U-bolt to distribute load evenly across the rope strands. The design resists loosening when the line is held under sustained tension rather than brief shock loads. Correct torque on the nuts maintains clamping force over long periods.
Simple bolt-on fitting with common tools
Installation requires only a wrench to tighten the two hex nuts to the specified torque. The most common error is reversing the saddle so it bears on the live end of the rope instead of the dead end. Another frequent mistake is spacing the clips too far apart, which reduces holding power.
Highlights
- Pack of ten clips covers multiple rigging points
- 5/8 inch size fits standard wire rope diameters
- California Prop 65 warning alerts to chemical exposure risks
- Manufacturer-direct shipping streamlines delivery for qualifying orders
- New condition ensures full structural integrity for lifting tasks
Specifications
| Brand | MIDWEST FASTENER |
|---|
Questions about this item
Does the 52195 clip set need any extra power or generate heat when installed on a line that runs continuously?
These are passive forged-steel clips; they draw no power, produce no heat and make no noise regardless of how long the rope stays under tension.
What tools or hardware must I already have to torque the 10 clips in this pack to the correct specification?
You will need a wrench or socket that fits the U-bolt nuts and a torque wrench calibrated to the clip manufacturer's recommended setting for 5/8 inch rope.
Can I mix these new 52195 clips with older galvanised clips already on the same wire rope without creating a weak point?
Mixing clip brands or vintages on one rope is not recommended because differing metallurgy and thread tolerances can cause uneven load sharing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
