MIDWEST FASTENER CORP
MIDWEST FASTENER CORP 36622 7/16" Spring Hose Clamps 20PK
Pack of 20 spring hose clamps sized 7/16 inch for securing hoses onto fittings
- Secure hose connections with spring tension design
- 20 clamps per pack for multiple repair jobs
- 7/16 inch size fits standard automotive hoses
- MIDWEST FASTENER brand trusted for hardware reliability
- New condition ensures full clamping performance out of the box
Hose Clamp Kit for Air Lines
This pack contains twenty spring hose clamps sized at 7/16 inch from Midwest Fastener Corp. They are designed to secure flexible hose onto barbed fittings in pneumatic systems. The spring action maintains constant tension as temperature and vibration change. Each clamp is ready for immediate use on compatible hose and fitting combinations.
Replaces Worm-Drive Clamps on Vibration-Prone Lines
Spring clamps install faster than screw-type worm drives because they require no tools once positioned. They are worth switching to when a connection sees frequent pressure cycles or engine vibration that can loosen a screw band. The constant radial force resists backing off without the need for periodic retightening.
Twenty-Piece Quantity Covers Multiple Connections
A single pack supplies enough clamps for several hose-to-fitting joints on a typical workshop compressor setup. The 7/16 inch diameter suits common small-bore air hose used with nailers, spray guns and inflators. It will not fit larger diameter supply lines or high-pressure hydraulic hose that exceeds the clamp's expansion range.
Highlights
- Secure hose connections with spring tension design
- 20 clamps per pack for multiple repair jobs
- 7/16 inch size fits standard automotive hoses
- MIDWEST FASTENER brand trusted for hardware reliability
- New condition ensures full clamping performance out of the box
Specifications
| Brand | MIDWEST FASTENER |
|---|
Questions about this item
What hose outer diameter do the 7/16" spring clamps fit?
The 7/16 inch size clamps onto hose with a matching outer diameter for a secure seal.
How are the spring hose clamps installed on the fitting?
Squeeze the spring arms with pliers, slide the clamp over the hose end, then release so the spring tension grips the barb.
When should the spring hose clamps be replaced?
Replace any clamp that shows corrosion, lost spring tension, or deformation after removal.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
