Micro 100
Micro 100 RTCM-080-2 Engraving Tool 12.00mm Carbide
Carbide engraving tool with 30-degree double tip and 12.00 mm length of cut
- 30-degree angle creates precise engraving detail
- 00 mm cut length handles deeper marking tasks
- Carbide construction resists wear for longer tool life
- Uncoated surface suits dry machining applications
- 00 mm shank fits standard metric tool holders
Precision Engraving Tool
The Micro 100 RTCM-080-2 is a solid-carbide engraving tool designed for detailed marking and cutting tasks. Its 30-degree included angle produces sharp, clean lines in a variety of workpiece materials. The 10.00 mm shank diameter fits compatible tool holders and collets directly. This accessory suits machinists and fabricators adding permanent identification or decorative details to components.
Upgrading From Basic Cutters
This tool replaces general-purpose cutters or worn engraving bits that leave ragged edges or wander in harder alloys. The carbide construction resists wear significantly longer than high-speed steel alternatives, maintaining geometry through extended production runs. The jump is worth it when consistent depth and crisp character definition become critical for part traceability or aesthetic standards. Orders of 75 or more units ship without extra freight charges.
Installation And Common Issues
The tool installs by clamping the 10.00 mm shank into a matching collet or holder, requiring only standard tightening torque. No special alignment fixtures or proprietary hardware are needed for basic operation. The most frequent issue is premature tip chatter caused by excessive run-out in worn spindles or incorrect speed and feed settings. Ensure the 12.00 mm length of cut matches the programmed depth to avoid tool deflection or workpiece damage.
Highlights
- 30-degree angle creates precise engraving detail
- 00 mm cut length handles deeper marking tasks
- Carbide construction resists wear for longer tool life
- Uncoated surface suits dry machining applications
- 00 mm shank fits standard metric tool holders
Specifications
| Brand | MICRO 100 |
|---|
Questions about this item
What shank diameter does the RTCM-080-2 require for mounting?
The engraving tool uses a 10.00 mm metric shank that fits compatible collets or holders.
How do I install the double-ended 30-degree tip without damaging the carbide?
Tighten the holder evenly on the shank only; do not apply torque to the cutting edges.
When should I replace the uncoated carbide engraving tool?
Replace it when the 30-degree cutting edges show visible wear or chipping.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
