Micro 100
Micro 100 RTCM-030-2X Engraving Tool 30 Degrees Carbide AlTiN 7.00 mm
Double-ended carbide engraving tool with a 30-degree tip, AlTiN coating and 7.00 mm cut length
- 30-degree tip cuts precise engraved lines
- 00 mm carbide length of cut handles deep marks
- AlTiN coating resists heat and wear
- Carbide body keeps edge sharp longer
- Double-ended design gives two tips per tool
Double-ended 30-degree engraving tool
The Micro 100 RTCM-030-2X is a carbide engraving tool designed for precision marking and detailing in machining operations. Its double-ended configuration provides two cutting points, effectively doubling tool life for high-volume workshops. The 30-degree included angle suits fine V-groove work and lettering on a variety of workpiece materials.
7.00 mm length of cut with AlTiN coating
The tool offers a 7.00 mm length of cut, giving adequate reach for shallow to medium-depth engraving passes in metals and plastics. The aluminium titanium nitride coating reduces friction and resists heat buildup, allowing higher spindle speeds and longer intervals between tool changes. Cutting performance drops off when engagement exceeds the stated length or when used on extremely abrasive alloys without coolant.
Replaces single-ended carbide engravers
Upgrading from a single-ended carbide engraver is worthwhile when changeover time dominates cycle time or when tool cost per edge is a concern. The double-ended design eliminates the need to reset tool length offsets as often, but it does not suit applications requiring a different included angle or a longer reach than 7.00 mm.
Highlights
- 30-degree tip cuts precise engraved lines
- 00 mm carbide length of cut handles deep marks
- AlTiN coating resists heat and wear
- Carbide body keeps edge sharp longer
- Double-ended design gives two tips per tool
Specifications
| Brand | MICRO 100 |
|---|
Questions about this item
Will this 30-degree carbide engraving tool fit the same collet or holder I use for other Micro 100 accessories?
The tool has a 7.00 mm length of cut and a 30-degree included angle; match those dimensions to your existing collet or holder specifications to confirm fit.
How can I verify the AlTiN coating is performing correctly after the first engraving pass?
Inspect the cut edges for clean, burr-free lines and consistent depth; AlTiN reduces built-up edge, so a smooth finish at the 30-degree angle indicates proper coating function.
Does the package include any collets, shims or mounting hardware, or must they be purchased separately?
The box contains only the double-ended carbide engraving tool; collets, shims and any mounting hardware are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
