Micro 100
Micro 100 RTC-187-23 Engraving Tool 7/16" Carbide
Carbide engraving tool with a 7/16" length of cut and 30-degree double angle
- 30-degree double angle for precise engraving
- 7/16 inch cut length handles detailed work
- Carbide construction resists wear in tough materials
- Uncoated surface suits a range of substrates
- 0040 inch tip radius creates fine lines
Engraving Tool for Precision Work
The Micro 100 RTC-187-23 is a carbide engraving tool designed for detailed cutting tasks. It suits machinists and fabricators who need a reliable accessory for powered or pneumatic equipment. The double-ended configuration provides two cutting points in a single holder.
Carbide Construction and Double-Ended Design
The uncoated carbide body resists wear during extended use on metal and other hard materials. A 30-degree included angle supports clean V-groove profiles and sharp lettering. Double-ended geometry allows the operator to flip the tool when one end dulls, reducing changeover time.
Ready-to-Use Cutting Accessory
The tool arrives with a 0.0040-inch tip radius and a 7/16-inch length of cut, enabling fine detail without additional grinding. No coatings or coatings-related preparation steps are required before installation. It mounts directly into compatible toolholders for immediate engraving work.
Highlights
- 30-degree double angle for precise engraving
- 7/16 inch cut length handles detailed work
- Carbide construction resists wear in tough materials
- Uncoated surface suits a range of substrates
- 0040 inch tip radius creates fine lines
Specifications
| Brand | MICRO 100 |
|---|
Questions about this item
What does the 30-degree angle mean for the cutting profile?
The 30-degree included angle creates a sharp V-shaped groove suitable for fine detail engraving and lettering.
What shank size does the RTC-187-23 require in the tool holder?
The tool uses a 7/16 inch shank diameter, so the holder or collet must match that size exactly.
How should the uncoated carbide tip be installed to avoid chipping?
Secure the shank fully in the collet before tightening, and avoid side loading the brittle carbide during the first plunge.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
