Micro 100
Micro 100 RSCM-040-2 Engraving Tool 10.00 mm 60° Carbide
Carbide engraving tool with a 10.00 mm cut length and 60° angle for precise detailing
- 00 mm cut length enables detailed engraving
- 60-degree carbide tip resists wear on hard materials
- Uncoated carbide suits general-purpose machining tasks
- Metric specification fits standard tool-holders
- Double-ended design provides two cutting edges
Micro 100 10 mm Engraving Tool
The Micro 100 RSCM-040-2 is a double-ended carbide engraving tool with a 10.00 mm length of cut. It is designed for precision marking and detailing on compatible workpieces. The uncoated carbide construction provides hardness for clean results in suitable materials. Machinists and fabricators use it for fine engraving tasks.
Installation and Common Issues
The tool fits standard holders that accept its shank configuration for quick setup. Ensure the holder is clean and the tool seats fully before tightening to prevent runout. A loose fit or misalignment often causes chatter and uneven lines. Excessive feed rates or incorrect spindle speed can also lead to premature tip wear.
Compatibility Checks
Verify that your machine’s tool holder matches the shank dimensions required for this engraving tool. Confirm the spindle can run at speeds appropriate for carbide tooling in your chosen material. Check that the 10.00 mm length of cut suits the depth requirements of your engraving programme. Ensure the 60-degree included angle matches the desired groove profile.
Highlights
- 00 mm cut length enables detailed engraving
- 60-degree carbide tip resists wear on hard materials
- Uncoated carbide suits general-purpose machining tasks
- Metric specification fits standard tool-holders
- Double-ended design provides two cutting edges
Specifications
| Brand | MICRO 100 |
|---|
Questions about this item
How do I verify the 60° engraving angle is cutting correctly after installation?
Check that the carbide tip produces clean, consistent V-grooves at the specified 10.00 mm length of cut without chatter or uneven edges.
What comes in the package and what must I source separately?
The box contains the uncoated carbide engraving tool only; you will need a compatible tool holder and machine spindle separately.
Which version should I choose for a 10.00 mm depth of cut?
Select the RSCM-040-2 model, which is specified for a 10.00 mm length of cut with a 60° included angle.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
