Micro 100
Micro 100 RSCM-030-1X Engraving Tool 7.00 mm 60 Degrees Carbide AlTiN
Carbide engraving tool with 60-degree tip, 7.00 mm length of cut and AlTiN coating
- 60° angle cuts clean V-grooves
- 00 mm carbide tip holds sharp edge
- AlTiN coating resists heat and wear
- Metric shank fits standard collets
- Single-flute design evacuates chips fast
Engraving Tool 7.00 mm 60 Degrees
This Micro 100 engraving tool is a single carbide cutter with a 60-degree included angle and a 7.00 mm length of cut. It is made for precision engraving on CNC or manual machines where a fine V-groove is required. The AlTiN coating adds wear resistance for longer tool life in production environments.
Carbide AlTiN Capacity and Headroom
The 7.00 mm cutting length defines the maximum groove depth achievable in a single pass without repositioning. Carbide construction with AlTiN coating handles steel, stainless steel and non-ferrous alloys at higher speeds than uncoated tools. It runs out when the required groove exceeds the 7.00 mm depth or when a wider included angle is needed for the application.
Build Fit and Clearance
The tool fits standard ER collets or end-mill holders that accept its shank diameter, freeing the spindle for quick changes between engraving and milling operations. It needs a rigid machine setup and appropriate coolant or mist to maintain the coating integrity. Buyers who need a different included angle or a longer reach must select another tool from the range.
Highlights
- 60° angle cuts clean V-grooves
- 00 mm carbide tip holds sharp edge
- AlTiN coating resists heat and wear
- Metric shank fits standard collets
- Single-flute design evacuates chips fast
Specifications
| Brand | MICRO 100 |
|---|
Questions about this item
Will the 7.00 mm length of cut suit the older CNC holder I already use?
The 7.00 mm length of cut fits standard metric holders; verify your holder accepts that dimension before mounting.
How do I confirm the 60-degree carbide tip is cutting correctly after installation?
Inspect the engraved groove for a clean 60-degree V-profile and consistent depth; chatter or burrs indicate alignment or feed-rate issues.
Does the box include the AlTiN-coated carbide tool only, or are collets and shims supplied?
Only the single engraving tool is included; collets, shims or holders must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
