Micro 100
Micro 100 RSCM-030-1 Engraving Tool 7.00 mm 60 Degrees Carbide
A 7.00 mm carbide engraving tool with a 60-degree tip for precision marking
- 60° tip angle cuts clean V-grooves in hard materials
- 00 mm length of cut gives controlled engraving depth
- Solid carbide construction resists wear during high-speed use
- Uncoated surface suits a wide range of workpiece materials
- Metric specification ensures direct fit in compatible toolholders
Engraving Tool with 7.00 mm Cut
The Micro 100 RSCM-030-1 is a single engraving tool made from uncoated carbide. It features a 60-degree included angle and a 7.00 mm length of cut. The tool is supplied new and ships directly from the manufacturer. It is intended for precision engraving tasks in a workshop environment.
Simple Toolholder Installation
Installation requires securing the tool shank into a compatible holder or collet. The carbide construction is brittle, so excessive tightening force or impact can cause the tip to fracture. Ensure the tool runs true in the spindle to prevent chatter marks on the workpiece. No additional setup steps are detailed by the supplier.
Verify Machine Compatibility First
Confirm that your machine accepts the tool shank diameter before ordering. Check that the spindle speed range suits uncoated carbide in your workpiece material. Buyers who need a coated tool for abrasive materials or a different included angle for specific profiles should look elsewhere. The supplier notes no state sales restrictions apply.
Highlights
- 60° tip angle cuts clean V-grooves in hard materials
- 00 mm length of cut gives controlled engraving depth
- Solid carbide construction resists wear during high-speed use
- Uncoated surface suits a wide range of workpiece materials
- Metric specification ensures direct fit in compatible toolholders
Specifications
| Brand | MICRO 100 |
|---|
Questions about this item
How do I confirm the 60-degree carbide tip is cutting correctly after mounting the RSCM-030-1 in my machine?
Run a test pass on scrap material; a clean, sharp V-groove with no chatter shows the 7.00 mm length of cut is engaged and the uncoated carbide is performing as intended.
What comes with the RSCM-030-1 and what must I supply separately?
The box contains the single 60-degree carbide engraving tool only; you must provide a compatible tool holder, collet or spindle adapter for your specific machine.
When should I choose the 7.00 mm length-of-cut version over other sizes?
Select the 7.00 mm cut length when your engraving depth or feature height requires that exact reach; shorter or longer lengths of cut are offered in other RSCM models for different depth needs.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
