Micro 100
Micro 100 RSC-375-24 Engraving Tool 1/2" 60° Carbide
Double-ended carbide engraving tool with a 60-degree included angle and .0040-inch tip radius for 1/2-inch length of cut
- 60° carbide tip cuts clean engraved lines
- 0040 in tip radius enables fine detail work
- 1/2 in length of cut provides ample reach
- Uncoated carbide resists wear in abrasive materials
- Double-ended design gives two cutting edges per tool
Micro 100 RSC-375-24 Engraving Tool
The Micro 100 RSC-375-24 is a double-ended carbide engraving tool with a 60 degree included angle. It provides a 1/2 inch length of cut and features an uncoated finish. Machinists and engravers use it for precise marking and detailing on various workpiece materials.
Carbide construction resists wear during extended
The solid carbide body maintains cutting geometry longer than high-speed steel alternatives under sustained engraving cycles. Its uncoated surface avoids coating delamination when running at consistent feed rates. The 0.0040 inch tip dimension holds tolerance across repeated passes without rapid degradation.
Double-ended design fits standard tool holders
Operators install the tool directly into compatible collets or holders sized for the shank. The symmetrical geometry allows either end to engage the workpiece, reducing setup time. Breakage occurs most often when excessive side load is applied or when the tip contacts hardened inclusions in the material.
Highlights
- 60° carbide tip cuts clean engraved lines
- 0040 in tip radius enables fine detail work
- 1/2 in length of cut provides ample reach
- Uncoated carbide resists wear in abrasive materials
- Double-ended design gives two cutting edges per tool
Specifications
| Brand | MICRO 100 |
|---|
Questions about this item
How much heat does the carbide tool generate during continuous engraving runs?
Carbide construction dissipates heat efficiently during extended use, maintaining cutting performance without thermal deformation.
What shank size must my machine spindle accept to hold this tool?
The tool requires a 1/2 inch shank capacity in your engraving spindle or collet system.
Will the .0040 inch tip radius match the finish quality of my existing carbide tooling?
The .0040 inch tip radius produces fine detail consistent with precision carbide engraving standards.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
