Micro 100
Micro 100 RSC-375-2 Engraving Tool 60° 1/2" Carbide
Carbide engraving tool with a 60° double tip and .0040 in tip width for 1/2 in cut length
- 60° angle cuts clean V-grooves for precise engraving
- Carbide construction resists wear for long tool life
- 1/2 inch length of cut handles deep marking tasks
- Uncoated surface suits a wide range of materials
- 0040 inch tip radius produces fine detail
Micro 100 Engraving Tool 60° Carbide
The Micro 100 RSC-375-2 is a double-ended engraving tool ground to a 60 degree included angle. It is manufactured from uncoated carbide and accepts a 1/2 inch length of cut with a .0040 inch tip radius. This accessory is intended for precision marking and engraving tasks on compatible power or pneumatic equipment.
Machinists needing a sharp 60 degree point
The 60 degree geometry suits operators cutting clean V-grooves, lettering or decorative lines in metals and plastics. Users requiring a different included angle, a coated substrate for abrasive materials, or a larger tip radius for heavier chip loads should select an alternative tool specification.
Uncoated carbide substrate ships ready to use
The tool arrives without a coating, so it can be sharpened or re-ground in-house to maintain the original 60 degree profile. No additional accessories, holders or software are bundled; the operator supplies the appropriate collet or tool holder for the machine spindle.
Highlights
- 60° angle cuts clean V-grooves for precise engraving
- Carbide construction resists wear for long tool life
- 1/2 inch length of cut handles deep marking tasks
- Uncoated surface suits a wide range of materials
- 0040 inch tip radius produces fine detail
Specifications
| Brand | MICRO 100 |
|---|
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
