Micro 100
Micro 100 CRE-312-125X Corner Rounding End Mill .1200 Carbide 3 Flute
Corner rounding end mill with 3 flutes in carbide and AlTiN coating for a .1200 radius
- TypeHole, Drill, Bore & Wire Gauges
- 3-flute carbide design produces smooth corner radii
- 1200 inch radius suits fine detail work
- AlTiN coating extends tool life in steel
- Straight shank fits standard collets and holders
- Double-ended layout gives two cutting ends per tool
Micro 100 CRE-312-125X corner rounding end mill
This carbide tool is built for machinists who need to break sharp edges with a consistent radius. The three-flute geometry and AlTiN coating support clean finishes in steel, stainless steel and other ferrous alloys. It suits both manual and CNC milling operations where a precise corner profile is required.
0.1200 inch radius with three-flute carbide
The cutter produces a 0.1200 inch corner radius in a single pass. Three flutes balance chip evacuation and surface finish while the solid carbide body resists wear at higher cutting speeds. AlTiN coating further reduces friction and extends tool life in demanding materials.
Runs cool with light cuts in typical milling
Carbide construction and the AlTiN layer keep temperatures low during normal profiling passes. Three flutes generate less vibration than two-flute alternatives, so noise stays moderate on rigid setups. Power draw remains modest when feeds and speeds follow standard carbide recommendations.
Highlights
- 3-flute carbide design produces smooth corner radii
- 1200 inch radius suits fine detail work
- AlTiN coating extends tool life in steel
- Straight shank fits standard collets and holders
- Double-ended layout gives two cutting ends per tool
Specifications
| Brand | Micro 100 |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
What does the .1200 corner radius mean once the cutter is in the spindle?
The .1200 inch radius will produce a consistent quarter-round profile on the workpiece edge when the tool is run at the correct feed and speed for the material.
What does the 3/50 inch shank cap in practice?
The 3/50 inch shank fits holders or collets sized for that diameter, limiting use to tooling that accepts this specific shank size.
What does the 3-flute carbide body need to fit or mount?
The straight-shank, 3-flute carbide body mounts in any standard end-mill holder or collet that matches the 3/50 inch shank diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
