We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

METRA

METRA TE-BR4PSK bumper waterproof connection rubber rear parking assist

SKU CH-NHM1-P66GS

Waterproof rubber bumper connector for universal rear parking assist sensors

  • FeaturesUNIVERSAL REAR BACK UP SENSORS
  • TypeOther Accessories
  • Universal rear parking sensors improve reversing safety
  • Waterproof bumper connection resists moisture and road spray
  • Rubber housing protects sensors from impact and vibration
  • Install Bay design fits a wide range of vehicle models
  • UPC 814792013557 ensures correct part identification

Universal Rear Parking Assist

The Metra TE-BR4PSK provides a waterproof bumper connection for universal rear backup sensors. It suits drivers adding parking assistance to vehicles without factory-fitted systems.

Bumper Waterproof Connection Rubber

The rubber housing seals the sensor wiring against moisture and road debris at the bumper. This protection maintains reliable signal transmission in wet or muddy conditions.

Simple Bumper Mount Installation

The unit fits into a drilled bumper hole and locks in place with the supplied rubber grommet. Incorrect hole diameter or missing sealant often causes water ingress later.

Highlights

  • Universal rear parking sensors improve reversing safety
  • Waterproof bumper connection resists moisture and road spray
  • Rubber housing protects sensors from impact and vibration
  • Install Bay design fits a wide range of vehicle models
  • UPC 814792013557 ensures correct part identification

Specifications

BrandInstall Bay
FeaturesUNIVERSAL REAR BACK UP SENSORS
TypeOther Accessories

Questions about this item

How often should the rubber grommets on the TE-BR4PSK be inspected or replaced?

Inspect the rubber grommets annually for cracking or hardening caused by weather exposure. Replace them if they no longer seal tightly around the sensor body to keep moisture out of the parking-assist wiring.

What is the first limitation you hit when the sensors run continuously in stop-and-go traffic?

The sensors are designed for intermittent reversing use; prolonged constant operation can cause the control module to overheat and temporarily disable the audible alerts until it cools.

Does the TE-BR4PSK add noticeable electrical load or heat when the vehicle is driven all day?

The kit draws only milliamps while active and the sensors stay at ambient temperature, so there is no measurable extra load on the battery or heat buildup during daily driving.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.