We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of black knit gloves with 3/4 dip coating, Kevlar and steel blend, ANSI cut level A4

Memphis

Memphis Glove Cut Gloves L Black Kevlar Steel Pair 9389PVL

SKU CH-P90N-Z5SWE

Black knitted gloves with Kevlar and steel fibres, ANSI/ISEA cut level A4 and abrasion level 4, meeting ANSI 105 and EN388 standards

  • ANSI/ISEA Cut Level A4 protects against sharp edges
  • ANSI/ISEA Abrasion Level 4 resists surface wear
  • Kevlar(R) and steel construction delivers high cut resistance
  • Meets ANSI 105 and EN388 standards for hand protection
  • 3/4 dipped coating enhances grip in dry and light-oil conditions

Cut-resistant gloves for general-purpose tasks

These Memphis gloves use a Kevlar and steel knit construction rated to ANSI/ISEA Cut Level A4 and Abrasion Level 4. They meet ANSI 105 and EN 388 standards for hand protection. The pair fits both left and right hands and is intended for general-purpose work where cut and abrasion hazards are present.

Coated grip and breathable knit design

A 3/4 dipped coating covers the palm and fingers to improve grip without fully sealing the back of the hand. The knit material allows air circulation during normal use so heat and moisture can escape. No double-dip layer is applied, keeping the glove flexible for extended wear.

ANSI/ISEA Cut Level A4 rating

This single rating defines the cut resistance the gloves deliver against sharp edges and materials. Buyers who need a higher cut level or specialised chemical protection should look for a different specification. The product carries California Proposition 65 warnings for cancer and reproductive harm.

Highlights

  • ANSI/ISEA Cut Level A4 protects against sharp edges
  • ANSI/ISEA Abrasion Level 4 resists surface wear
  • Kevlar(R) and steel construction delivers high cut resistance
  • Meets ANSI 105 and EN388 standards for hand protection
  • 3/4 dipped coating enhances grip in dry and light-oil conditions

Specifications

BrandMemphis Glove

Questions about this item

How do I put on the Memphis 9389PVL gloves so the 3/4 dip coating stays aligned with my palm?

Slide each hand in with the black Kevlar/steel knit facing outward, then pull the cuff until the dipped coating covers the palm and fingers but stops before the wrist; twisting the cuff while pulling is the step most people get wrong.

When will the ANSI/ISEA Cut Level A4 protection on these gloves need replacement?

Replace the pair once the black Kevlar/steel knit shows visible wear, the 3/4 dip coating peels, or the gloves no longer meet ANSI 105 and EN 388 cut and abrasion benchmarks during your regular inspection.

What limit appears first during sustained cutting work with the Memphis 9389PVL pair?

The ANSI/ISEA Abrasion Level 4 coating wears through before the Cut Level A4 fibres degrade, so grip loss on rough surfaces is the first sustained-use limit you will notice.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.