Mellanox Technologies
Mellanox MMA2P00-AS 25GbE SFP28 LC-LC 850nm SR 100m transceiver
A 25GbE SFP28 transceiver with LC duplex connectors operating at 850nm for up to 100m links
- 25 GbE throughput for high-speed links
- SFP28 form factor fits standard cages
- LC duplex connector for multimode fibre
- 850 nm wavelength optimised for short reach
- 100 metre range on OM3/OM4 cable
25GbE SFP28 transceiver for short-reach links
The Mellanox MMA2P00-AS is a single optical transceiver built for 25 gigabit Ethernet connections over multimode fibre. It uses an LC duplex connector and operates at an 850 nanometre wavelength. This module suits data-centre racks or campus networks where the link distance stays within 100 metres.
Steady 25 Gbps throughput over 100 metres
Under sustained load the transceiver maintains its rated 25 Gbps line rate across the full 100 metre reach without dropping to a lower speed. The 850 nm VCSEL laser and SFP28 electrical interface keep latency low and signal integrity stable during continuous traffic. No burst-only limitation applies; the link runs at full rate for as long as the switch port remains active.
SR optics limit reach to 100 metres on OM3/OM4
The short-range optical design caps the practical distance at 100 metres on standard multimode fibre; longer runs would require a different wavelength or single-mode module. The SFP28 form factor fits any compliant cage, but the SR specification means the transceiver cannot be used for extended-reach or long-haul links. Buyers needing kilometres of reach must select a separate LR or ER part.
Highlights
- 25 GbE throughput for high-speed links
- SFP28 form factor fits standard cages
- LC duplex connector for multimode fibre
- 850 nm wavelength optimised for short reach
- 100 metre range on OM3/OM4 cable
Specifications
No published specifications for this item yet.
Questions about this item
How much heat does the MMA2P00-AS generate when running 25 GbE traffic all day?
The module operates at 850 nm with SR optics rated for up to 100 m, typical of low-power SFP28 transceivers in this class.
What patch cable and switch port do I need to use this transceiver?
It requires an LC duplex multimode fibre patch cord and a free SFP28 port that supports 25 GbE speeds.
Will this transceiver link with my existing 10 GbE SFP+ switches?
The MMA2P00-AS is a 25 GbE SFP28 module; it will not negotiate down to 10 GbE on older SFP+ equipment.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



