Mayhew
Mayhew Extra Long Pin Punch 3/16 x 3/8 in
Extra-long pin punch for driving or removing pins in deep or tight spaces
- TypeHand Held Punches
- Extra-long 3/8 in. punch reaches deep pins
- 3/16 in. tip fits standard pin sizes
- Full finish resists corrosion during use
- Hand-held design gives direct striking control
- New condition ensures reliable performance out of box
Pin Punch 3/16 x 3/8 in
The Mayhew Extra Long Pin Punch is a hand-held striking tool sized at 3/16 by 3/8 inches for driving or removing pins in automotive and general mechanical work. Its extra-long body gives added reach into recessed holes or tight assemblies where standard punches cannot easily fit. The tool is supplied new and ready for workshop use.
Full-finish steel construction
The punch features a full-finish surface that resists corrosion and presents a smooth striking face to reduce mushrooming under repeated hammer blows. A knurled or tapered grip section allows secure handling even with oily gloves, and the slender 3/16 inch tip aligns precisely with small pin centres without damaging surrounding material.
Manual impact operation
Because the punch is driven entirely by hand-held hammer strikes, it produces no motor noise, vibration or air consumption figures and requires no compressor, hose or power supply. The operator controls each blow, so heat build-up in the tip is minimal and the tool remains cool during extended use. No external energy source is needed.
Highlights
- Extra-long 3/8 in. punch reaches deep pins
- 3/16 in. tip fits standard pin sizes
- Full finish resists corrosion during use
- Hand-held design gives direct striking control
- New condition ensures reliable performance out of box
Specifications
| Type | Hand Held Punches |
|---|
Questions about this item
What air inlet size and minimum hose size does the 2171XP require?
The 2171XP uses a 1/2 in. NPT air inlet and needs a minimum 1/2 in. hose to supply the 46 SCFM continuous air consumption.
What are the overall length and weight of the 2171XP?
The wrench measures 12.5 in. long and weighs 13.1 lbs., so check your workspace clearance and support before mounting.
How do you set the 3-position power regulator and swivel inlet on the 2171XP?
Select forward power level 1–3 or full reverse power, then rotate the 360-degree swivel inlet to align the hose without kinking; a common error is leaving the regulator on a low forward setting when maximum reverse torque is needed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
