We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black rectangular step-down module with three blunt-cut wires

Maxxima

Maxxima M50909 Step Down Module 24 to 12 VDC car electronics accessory

SKU CH-TQVA-BQXPQ

Steps 24 VDC down to 12 VDC at 1 A for LED lighting with blunt-cut wires

  • Converts 24 VDC systems to 12 VDC for LED lighting
  • Supplies up to 1 A continuous current for accessories
  • Blunt-cut wires allow direct solder or crimp connections
  • Compact step-down design fits tight vehicle compartments
  • Backed by a 1-year manufacturer warranty

Purpose and fit

The Maxxima M50909 step-down module converts a 24 VDC vehicle supply to a 12 VDC output for LED lighting. It suits installers who need a simple voltage reduction without a full wiring harness. The unit is not suited for high-current accessories or circuits that require regulated output beyond its 1 A rating.

Thermals noise and power

The module draws up to 1 A at the 12 VDC output, so heat dissipation stays low in typical LED lighting loads. No active cooling is included, and the supplier data gives no noise or thermal specifications. Power draw scales directly with the connected lighting load.

Accessories and software

Three blunt-cut wires provide the only connections, allowing direct soldering or crimping into existing loom. No connectors, mounting hardware or configuration software are supplied. The 1-year warranty noted by the manufacturer covers the module itself.

Highlights

  • Converts 24 VDC systems to 12 VDC for LED lighting
  • Supplies up to 1 A continuous current for accessories
  • Blunt-cut wires allow direct solder or crimp connections
  • Compact step-down design fits tight vehicle compartments
  • Backed by a 1-year manufacturer warranty

Specifications

BrandMAXXIMA

Questions about this item

How do I connect the three blunt-cut wires on the Maxxima M50909 step-down module?

Connect the input wires to the 24 VDC source and the output wires to the 12 VDC load, observing polarity; the third wire is typically ground and must be secured to chassis or common ground to complete the circuit.

What maintenance does the Maxxima M50909 require after installation?

No scheduled maintenance is needed; periodically inspect the blunt-cut wire connections for corrosion or loosening and verify the module stays within its 1 A current rating.

At what load does the Maxxima M50909 hit its limit during continuous use?

The module is rated for 1 A continuous output; sustained loads above this will cause voltage drop or thermal shutdown.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.