We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three-wire LED connector with black red white PVC leads ten inches long two ports overall twelve inches

Maxxima

Maxxima M50900 LED Connector 3-Pin 18 AWG 10 in Black Red White PVC

SKU CH-H3T6-NSNCM

Connects 18 AWG wires to LED lights with a 3-pin, 10-inch PVC pigtail rated for 14V DC

  • TypeElectrical Connectors
  • 3-pin LED connector simplifies strip lighting installs
  • 10 in pre-stripped leads reach tight channels
  • 18 AWG PVC conductors handle 14 V DC loads
  • Black red white colour code prevents wiring errors
  • Two connectors per pack complete a pair

3-Pin LED Connector Kit

The Maxxima M50900 kit supplies two 3-pin connectors with 10 in leads in black, red and white PVC. It is intended for installers joining or extending 18 AWG wiring on 14 V DC LED lighting circuits.

Upgrade From Crimp-And-Tape Joints

The pre-terminated pair replaces hand-crimped butt splices wrapped in electrical tape, cutting installation time and removing a common failure point. The jump is worth it when a job calls for repeatable, polarity-marked connections that can be disconnected for service.

Practical Limits Of 18 AWG At 14 V DC

At 18 AWG the conductors suit typical low-current LED strips but are not rated for higher-power arrays that would exceed the wire ampacity. The 12 in overall length restricts placement to adjacent modules, so longer runs demand a different wire gauge or junction method.

Highlights

  • 3-pin LED connector simplifies strip lighting installs
  • 10 in pre-stripped leads reach tight channels
  • 18 AWG PVC conductors handle 14 V DC loads
  • Black red white colour code prevents wiring errors
  • Two connectors per pack complete a pair

Specifications

BrandMAXXIMA
TypeElectrical Connectors

Questions about this item

What clearance is required for the 12 in overall length of the Maxxima M50900 LED connector?

The connector assembly measures 12 in end to end, so allow at least that much straight run plus room for the 10 in wire leads to bend without kinking.

How do you correctly attach the 18 AWG wires to the 3-pin connector without damaging the pins?

Strip each black, red and white lead to the recommended length, insert fully into the corresponding pin cavity until you feel a click, then tug gently to confirm a secure crimp.

When should the PVC-insulated 18 AWG leads be inspected or replaced in a 14V DC LED installation?

Check the insulation for cracking or discoloration annually; replace the harness if the PVC becomes brittle or if voltage drop across the 10 in leads exceeds acceptable limits.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.