Maxxima
Maxxima M42321R HVAC Control Red 140mA 12.8VDC
Red LED stop, turn and tail light drawing 140 mA at 12.8 VDC with sealed moisture-proof electronics and a plated brass connector
- ColorRed
- Red LED stop/turn/tail light for clear signalling
- Sealed polycarbonate housing resists moisture ingress
- 140 mA draw at 12.8 VDC for low power use
- Surface-mount design with plated brass connector
- Compact 3/4 in depth fits tight spaces
Maxxima M42321R HVAC Control Red
The Maxxima M42321R is a sealed LED stop, turn and tail light built for 12.8 VDC automotive electrical systems. Its polycarbonate housing and lens resist moisture and vibration in exterior mounting locations. The round 140 mA unit draws minimal current while providing the red illumination required for rear signalling functions.
Upgrade from incandescent stop-turn-tail bulbs
Replacing filament bulbs with this LED assembly eliminates the frequent burn-out cycles common on trailers and commercial vehicles. The sealed electronics prevent corrosion at the plated brass connector, so the jump is worth it when maintenance intervals need to be extended and downtime reduced.
140 mA load leaves ample circuit headroom
At 140 mA the light adds negligible demand to a standard 12.8 VDC lighting circuit, allowing multiple units on a single fuse without overload. The polycarbonate construction handles normal road spray and vibration, but the fixed surface-mount footprint limits use to flat panels with the exact cut-out dimensions.
Highlights
- Red LED stop/turn/tail light for clear signalling
- Sealed polycarbonate housing resists moisture ingress
- 140 mA draw at 12.8 VDC for low power use
- Surface-mount design with plated brass connector
- Compact 3/4 in depth fits tight spaces
Specifications
| Brand | Maxxima |
|---|---|
| Color | Red |
Questions about this item
What size mounting hole does the 42321R need for its 3/4 inch depth?
The light mounts on a flat surface and is 3/4 inch deep; no through-hole size is specified in the product data.
Which wire connects to the 12.8VDC supply on the plated brass connector?
Connect the supply to the plated brass connector; the housing is sealed so polarity must be observed at the connector pins.
How often should the sealed polycarbonate lens be replaced?
The sealed moisture-proof electronics and polycarbonate lens are designed for the life of the light; no scheduled replacement is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
