Maudlin Products
Maudlin Products slotted shim 4 in 0.050 in pack of 10
Pack of ten stainless steel slotted shims, each 4 in long and 0.05 in thick for precise spacing
- TypeAngle, Pitch & Slope Locators
- Precise alignment with 0.050 in stainless shims
- Ten shims per pack cover multiple spacing tasks
- ±0.001 in thickness tolerance ensures consistent fit
- 18-8 stainless steel resists corrosion in harsh environments
- Soft annealed temper allows easy trimming and forming
Precision alignment shims for machinery setup
This pack contains ten tabbed stainless-steel shims designed for accurate spacing and alignment tasks. Each piece measures four inches square with a nominal thickness of 0.050 in. The soft annealed 18-8 grade material allows easy handling and trimming on site. They suit maintenance technicians and millwrights who need repeatable shim stacks.
Slotted tabs simplify bolt-on installation
A 1 1/4 in wide slot runs 2 3/4 in deep, while a 3/4 in high tab extends 2 1/4 in wide for positive location on anchor bolts or studs. The plain finish resists corrosion without added coatings that could affect tolerance. Tight thickness tolerance of ±0.001 in and length or width tolerance of ±0.015 in keep stacks predictable during reassembly.
Thickness 0.050 in decides the stack height
The single critical dimension is the 0.050 in nominal thickness with its ±0.001 in tolerance. If the gap you must close falls outside the range this shim provides, the part will not work regardless of material or slot geometry. Buyers needing finer or coarser increments should select a different thickness grade.
Highlights
- Precise alignment with 0.050 in stainless shims
- Ten shims per pack cover multiple spacing tasks
- ±0.001 in thickness tolerance ensures consistent fit
- 18-8 stainless steel resists corrosion in harsh environments
- Soft annealed temper allows easy trimming and forming
Specifications
| Brand | Maudlin Products |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
How thick is each shim and what tolerance does it hold?
Each shim is 0.05 in thick with a thickness tolerance of ±0.001 in.
What are the slot and tab dimensions for fitment?
The slot is 1 1/4 in wide by 2 3/4 in deep; the tab is 3/4 in high by 2 1/4 in wide.
How are these shims installed and what mistake should be avoided?
Slide the tabbed slot over the bolt or stud, then tighten; do not force the shim or bend the tab, as the soft annealed 18‑8 stainless can deform.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
