Maudlin Products
Maudlin Products 316-025-12-50 Shim Roll 12x50 In .025 In Thk Annealed Stainless Steel 316
Annealed 316 stainless steel shim roll, 12 by 50 inches and .025 inch thick, tolerances .250 length, .010 width, .001 thickness, C40-45 hardness, 185 000 psi tensile
- TypeAngle, Pitch & Slope Locators
- Annealed 316 stainless resists corrosion in marine use
- Precise .025 in thickness with ±.001 in tolerance
- 12 in wide by 50 in long roll covers large gaps
- Meets AMS 5906B and ASTM-A-666-03 standards
- Soft temper allows easy forming without cracking
Precision Shim Stock
This annealed 316 stainless steel roll measures 12 inches wide by 50 inches long at a nominal 0.025 inch thickness. It is supplied new for machine builders and maintenance crews who need corrosion resistant spacing material in inch dimensions. The soft temper allows easy cutting and forming on site without work hardening.
Dimensional Control
Thickness tolerance is held to +/- 0.001 inch while width and length tolerances are +/- 0.010 and +/- 0.250 inch respectively. The plain finish and Rockwell C40 to 45 hardness deliver consistent shim behaviour under load. Conformance to AMS 5906B and ASTM A666 assures material traceability for quality systems.
Critical Thickness
The 0.025 inch gauge decides whether this roll fits the stack up; thinner or thicker stock will not meet the same spacing requirement. Buyers who need a different thickness or a harder temper must select another product. The small pack format suits low volume or prototype work.
Highlights
- Annealed 316 stainless resists corrosion in marine use
- Precise .025 in thickness with ±.001 in tolerance
- 12 in wide by 50 in long roll covers large gaps
- Meets AMS 5906B and ASTM-A-666-03 standards
- Soft temper allows easy forming without cracking
Specifications
| Brand | Maudlin Products |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
Will the .025 in thick annealed 316 stainless shim need periodic replacement?
The roll is made to AMS 5906B and ASTM A 666 03 with a Rockwell C 40 45 hardness and 185 000 psi tensile strength, so it resists wear and corrosion in normal spacing jobs without scheduled replacement.
What dimension limit is reached first when the roll is used continuously for shimming?
The 50 in length runs out before the 12 in width or the .025 in thickness, and the length tolerance of +/- .250 in is the widest of the three tolerances.
Does the shim roll generate heat or noise when left in place all day?
It is a passive metal strip with no moving parts or power draw, so it produces no heat and no noise during continuous use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
