Maudlin Products
Maudlin Products 316-020-6-100 Shim Roll 316 Annealed 6x100 In x0.508mm hand tool
Stainless steel 316 annealed shim roll, 6 in wide by 100 in long, 0.02 in thick for precision spacing
- TypeAngle, Pitch & Slope Locators
- Precise alignment with ±0.005 in width tolerance
- Consistent spacing using ±0.001 in thickness control
- Corrosion-resistant 316 stainless steel meets AMS 5906B
- Annealed temper allows easy hand forming and cutting
- 100 in roll length covers multiple shimming tasks
Precision Shimming Material
This annealed 316 stainless steel shim roll measures six inches wide by one hundred inches long with a nominal thickness of zero point zero two inches. It serves mechanics and fabricators who need corrosion resistant spacing material for alignment tasks. The soft temper allows easy cutting and forming with hand tools.
Capacity and Headroom
The roll provides one hundred inches of continuous length for multiple cut pieces while the six inch width covers broad joint gaps. Thickness tolerance of plus or minus zero point zero zero one inches ensures consistent spacing in precision assemblies. Length tolerance of plus or minus zero point two five inches and width tolerance of plus or minus zero point zero zero five inches define the dimensional limits.
Critical Specification
Material grade 316 stainless steel meeting AMS 5906B and ASTM A 666 03 standards with a Rockwell hardness range of C forty to forty five and tensile strength of one hundred eighty five thousand psi. Buyers needing magnetic response or higher strength alloys should select a different grade.
Highlights
- Precise alignment with ±0.005 in width tolerance
- Consistent spacing using ±0.001 in thickness control
- Corrosion-resistant 316 stainless steel meets AMS 5906B
- Annealed temper allows easy hand forming and cutting
- 100 in roll length covers multiple shimming tasks
Specifications
| Brand | Maudlin Products |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
Will the 0.02 in thickness and ±0.001 in tolerance sit cleanly against existing 316 stainless surfaces without galvanic issues?
Yes, the roll is 316 stainless annealed to C40-45 hardness with a plain finish, so it matches the alloy and surface condition of typical 316 components.
How can I confirm the shim meets the ±0.001 in thickness tolerance after I cut a piece?
Measure the cut strip with a calibrated micrometer; the material is certified to AMS 5906B and ASTM A666-03 with thickness tolerance ±0.001 in.
Does the 6 in × 100 in roll include any adhesive backing or cutting tools, or must I supply those?
The pack contains only the plain-finish annealed 316 stainless shim stock; adhesive and cutting tools are not included.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
