Maudlin Products
Maudlin Products 316-015-6-100 Shim Roll 316 Annealed 6x100 In x0.381mm hardware
Stainless-steel 316 annealed shim roll, 6 inches wide by 100 inches long and 0.015 inches thick, for precision spacing
- TypeShims and Shim Stock
- Size6 x 100"
- Precise alignment with ±0.001 in thickness tolerance
- Consistent 6-inch width held to ±0.005 in tolerance
- Reliable spacing using 316 stainless meeting AMS 5906B and ASTM A666
- 100-inch roll length allows custom cuts with ±0.250 in tolerance
- Soft annealed temper at Rockwell C40-45 eases forming and fitting
Precision Alignment Shim Roll
This 316 stainless steel shim roll is designed for technicians and engineers who need precise spacing in mechanical assemblies. The annealed temper makes the material easy to cut, form, and fit during installation or maintenance work. It suits applications where corrosion resistance and dimensional accuracy are required.
Annealed 316 Stainless Construction
The soft temper allows hand tools to shape the material without cracking while meeting AMS 5906B and ASTM-A-666-03 quality standards. A plain silver finish provides a clean surface for measuring and positioning. Rockwell hardness ranges from C40 to C45 with a tensile strength of 185,000 psi.
Verify Thickness And Tolerance Requirements
Confirm that the 0.015 inch nominal thickness with a +/- 0.001 inch tolerance matches your stack-up calculations before ordering. Check that the 6 inch width and 100 inch length provide enough stock for the number of shims needed. Ensure the +/- 0.005 inch width and +/- 0.250 inch length tolerances are acceptable for your fixturing.
Highlights
- Precise alignment with ±0.001 in thickness tolerance
- Consistent 6-inch width held to ±0.005 in tolerance
- Reliable spacing using 316 stainless meeting AMS 5906B and ASTM A666
- 100-inch roll length allows custom cuts with ±0.250 in tolerance
- Soft annealed temper at Rockwell C40-45 eases forming and fitting
Specifications
| Brand | MAUDLIN PRODUCTS |
|---|---|
| Type | Shims and Shim Stock |
| Size | 6 x 100" |
Questions about this item
What stainless-steel grade and temper is the shim stock made from?
It is 316 stainless steel in the soft annealed temper, meeting AMS 5906B and ASTM-A-666-03.
What are the exact width, length and thickness dimensions with their tolerances?
6 in wide by 100 in long by .015 in thick; width tolerance +/- .005 in, length tolerance +/- .250 in, thickness tolerance +/- .001 in.
How do you cut and fit the roll, and what mistake should you avoid?
Measure the gap, mark the strip, cut with aviation snips or a fine-tooth hacksaw, deburr the edges, then test-fit; the common error is trimming too short because the .250 in length tolerance can leave the piece slightly shorter than marked.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
