Maudlin Products
Maudlin Products 316-010-6-50 Shim Roll 6 x 50 In 0.01 In Thick Stainless Steel 316 Annealed
Stainless steel 316 shim roll, 6 in by 50 in, 0.01 in thick, annealed to Rockwell C40-45 for vibration cushioning
- TypeAngle, Pitch & Slope Locators
- Precise alignment with +/- 0.001 in thickness tolerance
- Vibration cushioning from soft annealed 316 stainless
- Corrosion-resistant 316 grade meets AMS 5906B & ASTM A666
- High 185,000 psi tensile strength for durability
- Ready-to-cut 6 x 50 in roll with tight width tolerance
Precision shim stock for vibration control
This annealed 316 stainless steel shim roll measures six inches wide by fifty inches long with a point-zero-one inch thickness. It meets AMS 5906B and ASTM-A-666-03 standards and carries a Rockwell hardness of C40-45 with tensile strength of 185,000 psi. The soft temper allows easy forming while the alloy resists corrosion in harsh environments. Machinists and maintenance crews use it to cushion and absorb vibration in precision assemblies.
Fits tight clearances and custom lengths
The roll format lets you cut exact lengths on site without waiting for custom parts. Width tolerance is held to plus-or-minus point-zero-zero-five inches and thickness tolerance to plus-or-minus point-zero-zero-one inches, so shims stack predictably. Length tolerance is plus-or-minus point-two-five inches over the full fifty inches. No adhesive backing or special tools are required; the material cuts with standard shears and conforms to irregular surfaces.
Replaces thicker or less corrosion-resistant shims
When existing carbon steel or thinner alloy shims corrode or work-harden, this 316 grade maintains dimensional stability and chemical resistance. The jump is worth it for marine, chemical or food-grade equipment where contamination or premature failure is unacceptable. Builders needing pre-cut shapes, adhesive backing or thicknesses other than point-zero-one inch should look elsewhere.
Highlights
- Precise alignment with +/- 0.001 in thickness tolerance
- Vibration cushioning from soft annealed 316 stainless
- Corrosion-resistant 316 grade meets AMS 5906B & ASTM A666
- High 185,000 psi tensile strength for durability
- Ready-to-cut 6 x 50 in roll with tight width tolerance
Specifications
| Brand | Maudlin Products |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
How flat does the 0.01 in shim stay after a full day of bolting and vibration?
The annealed 316 stainless holds a Rockwell C40-45 hardness and 185,000 psi tensile strength, so it resists permanent set under normal clamping loads.
Does the roll get hot or noisy when left in a machine that runs continuously?
The material is passive metal shim stock; it generates no heat, draws no power and makes no sound during operation.
What tools or surface preparation are needed before the shim can be used?
Only standard shears or snips to cut the 6 in by 50 in roll to length; the plain silver finish requires no cleaning or coating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
