Maudlin Products
Maudlin Products 316-002-12-50 Shim Roll 12x50 In 0.051mm
Stainless-steel 316 shim roll, 12 by 50 inches and 0.002 inch thick, annealed for easy cutting and precise spacing
- TypeAngle, Pitch & Slope Locators
- Precise alignment with ±0.0001 in thickness tolerance
- Consistent spacing from 0.002 in annealed stainless shim
- Corrosion-resistant 316 grade meets AMS 5906B & ASTM-A-666-03
- Reliable fit ensured by ±0.250 in length & ±0.010 in width tolerances
- High-strength 185,000 psi material withstands demanding applications
Precision Spacing Shim Roll
This 316 stainless steel shim roll provides thin, consistent spacing material for alignment tasks. The annealed temper keeps the foil soft enough to form by hand while retaining strength. It suits machinists, maintenance technicians and toolmakers who need adjustable fit-up in assemblies.
Build Quality And Handling
The roll measures 12 inches wide by 50 inches long with a thickness of 0.002 inch and a tolerance of +/- 0.0001 inch. Width tolerance is +/- 0.010 inch and length tolerance is +/- 0.250 inch. The plain silver finish and soft temper allow easy cutting and shaping on the bench without spring-back.
Application Limits
Rockwell hardness falls between C40 and C45 with a tensile strength of 185,000 psi, so the material resists deformation under moderate clamping loads. It meets AMS 5906B and ASTM A 666-03 standards for corrosion-resistant 316 grade. The foil is not suited for structural load-bearing or high-wear sliding surfaces.
Highlights
- Precise alignment with ±0.0001 in thickness tolerance
- Consistent spacing from 0.002 in annealed stainless shim
- Corrosion-resistant 316 grade meets AMS 5906B & ASTM-A-666-03
- Reliable fit ensured by ±0.250 in length & ±0.010 in width tolerances
- High-strength 185,000 psi material withstands demanding applications
Specifications
| Brand | Maudlin Products |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
What thickness does the 0.002 in stainless steel shim roll provide for spacing?
The roll is 0.002 in thick with a tolerance of +/- 0.0001 in, made from annealed 316 stainless steel for precise spacing.
What are the exact width and length dimensions of the 12x50 in shim roll?
Width is 12 in with +/- 0.010 in tolerance, length is 50 in with +/- 0.250 in tolerance.
How do I cut and install the annealed 316 stainless shim without work-hardening the edges?
Cut with sharp shears or a fine-tooth blade, deburr edges, and avoid excessive bending which can raise hardness above Rockwell C40-45.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
