Maudlin Products
Maudlin Products 002-6-100 Shim Roll 302 Full Hard 6x100 In x 0.051mm hand tool
Precision 18-8 stainless steel shim roll, 6 in. wide by 100 in. long at 0.002 in. thickness, full hard temper for corrosion-resistant alignment in oil, gas and desalination applications
- TypeAngle, Pitch & Slope Locators
- Precise alignment with ±0.005 in width tolerance
- Consistent 0.002 in thickness for exact spacing
- Full-hard 302 stainless steel resists corrosion in harsh environments
- 100 in roll allows custom lengths for any job
- Meets AMS-5906 and ASTM-A-666 quality standards
Precision Shim Stock for Corrosive Environments
This roll supplies 18-8 stainless steel shim stock in a full-hard temper for alignment and spacing tasks. The material meets AMS-5906 and ASTM-A-666 standards for consistent quality. It is suited for maintenance crews in oil refineries and desalination plants where corrosion resistance is critical. The silver finish identifies the plain, uncoated surface.
Dimensional Tolerances Define Fit
Thickness is held to +/- 0.0001 in, width to +/- 0.005 in, and length to +/- 0.250 in. These tolerances determine whether the shim can close a specific gap without forcing or loosening over time. The 0.002 in nominal thickness provides a fine adjustment increment. Builders needing tighter or looser control must verify these limits against their assembly requirements.
0.002 Inch Thickness Governs Selection
The single specification that decides suitability is the 0.002 in nominal thickness with its 0.0001 in tolerance. If the design gap calls for a different step size, this roll cannot be used. The 6 in width and 100 in length only affect how many pieces you can cut. Buyers who need a different thickness must source another grade.
Highlights
- Precise alignment with ±0.005 in width tolerance
- Consistent 0.002 in thickness for exact spacing
- Full-hard 302 stainless steel resists corrosion in harsh environments
- 100 in roll allows custom lengths for any job
- Meets AMS-5906 and ASTM-A-666 quality standards
Specifications
| Brand | Maudlin Products |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
Which thickness should I choose for precise alignment?
The roll is 0.002 in thick with a tolerance of +/- 0.0001 in, suitable for fine shimming tasks.
What does the 0.002 inch thickness mean when installed?
It provides a consistent 0.051 mm gap with a tight +/- 0.0001 in tolerance for accurate spacing.
What material standard does the stainless steel meet?
The 18-8 stainless meets AMS-5906 and ASTM-A-666 for corrosion resistance and hardness.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
