Malco
Malco HC1D Thrust Bearing for 1ELG5 1ELH8 Cutters tool storage
A thrust bearing for 1ELG5 and 1ELH8 hole cutters with 1 1/16 in length
- Thrust bearing enables smooth cutter operation
- 1 1/16 inch overall length fits 1ELG5 and 1ELH8 models
- Impact rated no for standard drilling tasks
- Malco brand ensures professional tool quality
- Ships free on orders of 75 or more
Thrust Bearing for Hole Cutters
The Malco HC1D thrust bearing is a replacement component designed for 1ELG5 and 1ELH8 hole cutters. It supports the axial load generated during cutting operations. Professional tradespeople and maintenance technicians use it to keep their cutters running smoothly.
Replaces Worn Bearing Assembly
This bearing replaces the original thrust bearing when it shows excess play or noise during use. The upgrade is worth it when the cutter binds or produces an uneven hole edge. A fresh bearing restores the tool’s cutting accuracy without buying a new cutter.
Simple Press-Fit Installation
Installation involves removing the old bearing and pressing the new one into place with basic hand tools. The main issue occurs if the bearing seats crookedly, which causes vibration and premature wear. Clean the bore thoroughly before fitting to avoid debris trapping.
Highlights
- Thrust bearing enables smooth cutter operation
- 1 1/16 inch overall length fits 1ELG5 and 1ELH8 models
- Impact rated no for standard drilling tasks
- Malco brand ensures professional tool quality
- Ships free on orders of 75 or more
Specifications
| Brand | MALCO |
|---|
Questions about this item
What overall length must the 1 1/16 in thrust bearing match on the 1ELG5 and 1ELH8 cutters?
The thrust bearing has an overall length of 1 1/16 in and is designed specifically for use with the 1ELG5 and 1ELH8 hole cutters.
How is the thrust bearing installed on the cutter, and what common step is missed?
The bearing fits onto the cutter arbor; the step often missed is seating it fully against the cutter shoulder before tightening the retaining nut.
When should the thrust bearing be replaced on the 1ELG5 or 1ELH8 cutter?
Replace the bearing when axial play appears, the cutter binds during drilling, or the bearing surface shows scoring or pitting.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
