Mag-Mate
Mag-Mate PLC200 Straight Hose Clamp Pliers 9 In
Straight hose clamp pliers with a fingertip locking pawl and 2-1/4 in maximum jaw opening
- TypePliers
- MaterialHAWA
- Straight jaws reach tight engine bays
- Finger-tip locking pawl holds clamp open
- Heavy-duty steel construction resists wear
- 2-1/4 in maximum jaw opening fits large clamps
- Red handles give quick visual identification
Straight hose clamp pliers
The Mag-Mate PLC200 straight hose clamp pliers are built for technicians who need reliable grip on constant-tension and standard hose clamps. A fingertip locking pawl holds the jaws in position so you can apply steady force without the tool slipping off the clamp.
Check clearance before ordering
Verify that the straight jaw profile fits the hose routing in your engine bay and that the maximum jaw opening of two and one quarter inches covers the clamps you service. The nine inch overall length must also reach the fastener without interference from surrounding components.
Heavy duty steel with red handles
Constructed from heavy duty steel, the pliers resist distortion under high clamping loads. The red handle coating provides a visible, non-slip grip during repetitive use, and the straight design allows direct access where angled pliers cannot reach.
Highlights
- Straight jaws reach tight engine bays
- Finger-tip locking pawl holds clamp open
- Heavy-duty steel construction resists wear
- 2-1/4 in maximum jaw opening fits large clamps
- Red handles give quick visual identification
Specifications
| Brand | MAG-MATE |
|---|---|
| Type | Pliers |
| Material | HAWA |
Questions about this item
What comes with the Mag-Mate PLC200 pliers and is anything else needed to use them?
The pliers include a finger-tip locking pawl and red handles made of heavy-duty steel. No separate parts are required for standard hose clamp operation.
The model number is PLC200 — does the 200 indicate a size or capacity I should match to my job?
PLC200 is the manufacturer's model designation for this straight 9-inch hose clamp pliers. It does not represent a jaw measurement or clamp-size rating.
The specs list a maximum jaw opening of 2-1/4 in — what does that mean when I am working on a real hose clamp?
The jaws can spread up to 2-1/4 inches, so they will fit over most standard automotive and industrial hose clamps within that range.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
