We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Carbon steel weld-on pad eye with oval ring, plain steel finish

Mag-Mate

Mag-Mate PE0200 Pad Eye 11/16" depth 4,000 lb WLL

SKU CH-ZV6V-TYX7N

Carbon steel pad eye with an 11/16 in depth and a 4,000 lb working load limit for weld-on mounting

  • MaterialHAWA
  • Weld-on mounting creates a permanent anchor point
  • Carbon steel construction delivers 4,000 lb working load limit
  • ASME BTH-1 compliance confirms structural integrity
  • 11/16 inch depth suits low-profile installations
  • One-year manufacturer warranty backs material quality

Pad Eye Weld-On Mounting

The Mag-Mate PE0200 is a carbon steel pad eye designed for permanent weld-on installation on vehicles or equipment. It provides a fixed anchor point for lifting or securing loads with a working load limit of 4,000 lb. The unit meets ASME BTH-1 standards and includes a date code for traceability.

Sustained Load Behaviour

Under continuous load the carbon steel body resists deformation up to the rated working load limit of 4,000 lb. The weld-on base distributes force across the mounting surface rather than concentrating stress on a single fastener. The steel finish protects the material during extended outdoor exposure.

Pre-Installation Checks

Verify that the mounting surface is suitable for welding and can support the 4,000 lb working load limit without distortion. Confirm the 11/16 in depth and 3-1/4 in length match the available space on your equipment. Ensure welding procedures follow applicable structural codes for the intended application.

Highlights

  • Weld-on mounting creates a permanent anchor point
  • Carbon steel construction delivers 4,000 lb working load limit
  • ASME BTH-1 compliance confirms structural integrity
  • 11/16 inch depth suits low-profile installations
  • One-year manufacturer warranty backs material quality

Specifications

BrandMAG-MATE
MaterialHAWA

Questions about this item

Does the 11/16 in depth of the PE0200 pad eye affect how much heat builds up during continuous welding?

The carbon steel body dissipates heat normally during weld-on installation; no special cooling is required for the 11/16 in depth.

What base material must I already have to weld the PE0200 pad eye in place?

A clean carbon steel structure at least 11/16 in thick is needed for a full-penetration weld on the PE0200.

Will the 43/64 in ring diameter of the PE0200 accept the same shackles I use on older 1/2 in pad eyes?

The 43/64 in ring is larger than a 1/2 in ring, so existing shackles with a 1/2 in pin will fit with clearance.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.