M.A. Ford
M.A. Ford Twister Xd 7X+ Coolant Fed Drill 8.90mm 2XDCL3504A
Coolant-fed drill bit delivers through-coolant drilling at 8.90 mm diameter
- Coolant-fed design flushes chips for cleaner holes
- Twister Xd 7X+ geometry improves drilling performance
- 90 mm diameter suits precise machining tasks
- M.A. Ford quality ensures reliable tool life
- New condition delivers full factory performance
8.90 mm coolant-fed drill
The M.A. Ford Twister Xd 7X+ is a solid-carbide drill with internal coolant delivery designed for production drilling in steel and cast iron. Its 8.90 mm diameter suits CNC machines and high-rigidity machining centres where through-tool coolant is available. The tool targets shops that need consistent hole quality at elevated speeds.
Thermal management and power draw
Internal coolant channels direct fluid to the cutting zone, reducing heat build-up and extending edge life during deep-hole cycles. The design lowers cutting temperatures compared with external flood coolant alone. Stable temperatures help maintain dimensional accuracy throughout long runs.
California Proposition 65 notice
The product carries a Proposition 65 warning for chemicals known to the State of California to cause cancer and reproductive harm. No bundled accessories or software are included with the drill. Users must provide compatible tool holders and coolant filtration themselves.
Highlights
- Coolant-fed design flushes chips for cleaner holes
- Twister Xd 7X+ geometry improves drilling performance
- 90 mm diameter suits precise machining tasks
- M.A. Ford quality ensures reliable tool life
- New condition delivers full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 8.90mm coolant-fed drill in a machine spindle and what step is often missed?
Secure the shank fully in a compatible holder, then connect the coolant line to the through-tool port before starting; the step most often missed is verifying coolant flow through the flute exits.
What maintenance or replacement will the Twister Xd 7X+ drill need during its service life?
Inspect the cutting edges for wear after each job; replace the drill once the 8.90mm diameter falls below tolerance or when flank wear reaches the manufacturer's regrind limit.
What limit appears first when the drill runs continuously in deep holes?
Chip evacuation through the 7X+ length flute becomes the limiting factor before thermal buildup, so maintain recommended feed rates and coolant pressure to avoid packing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
