M.A. Ford
M.A. Ford Twister XD 5X Solid Carbide Drill 10.80 mm 2XDSR4252A
A 10.80 mm solid carbide drill built for five-times-diameter holes in demanding materials
- 80 mm diameter drills precise holes in tough materials
- 5× diameter flute length reaches deep without pecking
- Solid carbide construction resists wear at high cutting speeds
- Twister XD geometry improves chip evacuation in steel and alloys
- California Proposition 65 warning discloses regulated chemical content
Twister XD 5X Solid Carbide Drill
The Twister XD 5X is a solid carbide drill manufactured by M.A. Ford for precision hole-making in demanding materials. Its 10.80 mm diameter suits production and maintenance tasks that require consistent accuracy. The tool is supplied new and carries the manufacturer part number 2XDSR4252A. California Proposition 65 warnings apply to this product.
Upgrading from standard twist drills
This drill replaces conventional high-speed steel or general-purpose carbide bits when hole quality and tool life become critical. The 5X diameter-to-length ratio supports deeper holes without pecking cycles in many materials. The jump is worth it when scrap rates or frequent regrinds outweigh the higher upfront cost of solid carbide.
Sustained cutting performance
Solid carbide construction maintains rigidity and edge integrity during extended cuts, reducing deflection compared with brazed or steel alternatives. Heat resistance allows consistent feed rates through the full depth of cut. The design targets stable chip evacuation in continuous drilling operations rather than intermittent use.
Highlights
- 80 mm diameter drills precise holes in tough materials
- 5× diameter flute length reaches deep without pecking
- Solid carbide construction resists wear at high cutting speeds
- Twister XD geometry improves chip evacuation in steel and alloys
- California Proposition 65 warning discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter and holder type does the 10.80 mm Twister XD 5X drill require?
It has a 10.80 mm cylindrical shank, so use a precision collet or hydraulic chuck that matches that exact diameter for true running.
Which drilling practice avoids breaking the solid-carbide 2XDSR4252A on entry?
Start at reduced feed with a centre drill or short pilot hole, then ramp to full feed — plunging at full load snaps the carbide.
When should the 10.80 mm Twister XD drill be replaced?
Replace it once flank wear reaches the maker's wear limit, the cutting corners chip, or thrust force spikes — solid carbide is not economically resharpened.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
