M.A. Ford
M.A. Ford Twister XD 5X Coolant Fed Drill 9.70mm 2XDCR3819A
A 9.70 mm coolant-fed drill for high-performance drilling applications
- Coolant-fed design improves chip evacuation during deep drilling
- 5X diameter capability reaches greater depths in a single pass
- 70 mm cutting diameter suits precise hole-making tasks
- Twister XD geometry enhances tool life in tough materials
- M.A. Ford manufacturing delivers consistent performance for professionals
9.70 mm Coolant-Fed Drill
The M.A. Ford Twister XD 5X is a coolant-fed drill with a 9.70 mm cutting diameter. It is built for machine shops and maintenance teams that need through-tool coolant delivery for deep-hole drilling in steel and alloys. The design targets production environments where chip evacuation and tool life are critical.
Suited for high-volume metal drilling.
This drill suits CNC operators and tooling engineers running dedicated cycles with internal coolant supply. It does not suit buyers who need a general-purpose twist drill for portable drills, nor teams without through-spindle coolant capability or without rigid machine-tool holding.
Requires through-coolant spindle and rigid holder
The tool fits into a build that provides internal coolant pressure and a precision tool holder matched to the 2XDCR3819A shank. It frees the operator from peck cycles by flushing chips continuously, reducing cycle time and protecting the cutting edges during deep cuts.
Highlights
- Coolant-fed design improves chip evacuation during deep drilling
- 5X diameter capability reaches greater depths in a single pass
- 70 mm cutting diameter suits precise hole-making tasks
- Twister XD geometry enhances tool life in tough materials
- M.A. Ford manufacturing delivers consistent performance for professionals
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle or holder is required to run the 9.70 mm Twister XD 5X coolant-fed drill?
The drill has a 9.70 mm cutting diameter and a coolant-fed design, so it needs a compatible spindle or holder that accepts a 9.70 mm shank and provides through-tool coolant delivery.
Can the Twister XD 5X drill be used in an older CNC that only offers external flood coolant?
The drill is built for through-spindle coolant; without internal coolant delivery it cannot evacuate chips as intended and may overheat or wear prematurely.
How can I confirm the Twister XD 5X is cutting correctly after installation?
Check for consistent chip formation, stable spindle load, and hole diameter holding at 9.70 mm; the coolant-fed design should produce a steady coolant stream through the tool.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
