M.A. Ford
M.A. Ford Twister XD 5X Coolant Fed Drill 7.00 mm 2XDCR2756A
A 7.00 mm coolant-fed drill with 5x diameter depth capability for deep-hole drilling
- 5x diameter drilling depth for fewer tool changes
- Coolant-fed design clears chips from deep holes
- 00 mm diameter suits precise hole sizing
- M.A. Ford Twister XD line built for hard materials
- California Proposition 65 chemical warning applies
Product Identity
The M.A. Ford Twister XD 5X Coolant Fed Drill is a new cutting tool designed for precision holemaking in demanding materials. Its 7.00 mm diameter and internal coolant delivery suit high-performance metalworking applications where chip evacuation and tool life are critical. The 5X length-to-diameter ratio supports deeper drilling without pecking cycles. MPN 2XDCR2756A identifies this specific configuration.
Who This Suits
Machinists and shops running CNC centres with through-spindle coolant capability will benefit from the coolant-fed design and extended reach. It is not suited for handheld drilling or machines lacking internal coolant supply. Buyers who need a larger or smaller diameter, a different flute length, or a non-coolant-fed geometry should look at alternative tooling. The California Proposition 65 notice also applies for regulated environments.
Deciding Specification
The 7.00 mm cutting diameter is the single dimension that determines whether this drill matches the required hole size. Verify the target hole tolerance and material specifications against this exact diameter before purchase. No other specification in the data overrides this fit criterion.
Highlights
- 5x diameter drilling depth for fewer tool changes
- Coolant-fed design clears chips from deep holes
- 00 mm diameter suits precise hole sizing
- M.A. Ford Twister XD line built for hard materials
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle taper or holder do I need to run the 7.00 mm Twister XD 5X coolant-fed drill?
The drill uses a standard cylindrical shank; fit it into a collet chuck, hydraulic holder or shrink-fit holder that accepts 7.00 mm diameter and supplies coolant through the tool.
Will the 2XDCR2756A drill work in an older CNC without through-spindle coolant?
It requires internal coolant delivery; without through-spindle or flood coolant directed into the flutes the drill will overheat and fail.
How can I verify the Twister XD 5X is cutting correctly after installation?
Check for steady chip evacuation, consistent hole diameter at 7.00 mm, no discoloration on the flutes and stable spindle load readings.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
