M.A. Ford
M.A. Ford Twister XD 5X 2XDSR3898A 9.90 mm drill
Solid carbide drill bit with 5× diameter reach for deep holes at 9.90 mm
- Solid carbide construction resists wear for long tool life
- 90 mm diameter suits precise hole-making tasks
- Twister XD 5X geometry improves chip evacuation
- Designed for power and pneumatic tool compatibility
- California Proposition 65 warning indicates regulated substances present
9.90 mm solid carbide drill
The M.A. Ford Twister XD 5X 2XDSR3898A is a solid carbide drill with a 9.90 mm cutting diameter. It is designed for machinists and maintenance teams who need a rigid tool for accurate holemaking in ferrous and non-ferrous materials. The solid carbide construction resists deflection better than high-speed steel alternatives. This item is supplied new and ships directly from the manufacturer.
Prop 65 chemical warning applies
California Proposition 65 notices state that this product contains a chemical known to the state to cause cancer and a chemical known to cause birth defects or other reproductive harm. Users must follow workplace safety regulations for handling, dust control and personal protective equipment. The warning does not describe a performance limit but it does impose a compliance requirement. Buyers who cannot meet those obligations should select a different tool.
Replaces high-speed steel drills
This drill upgrades from conventional high-speed steel bits where longer tool life and tighter tolerances are required. The jump is worth it when production volumes justify the higher upfront cost and when the machine spindle provides sufficient rigidity. It is not suited for hand-held drilling or for set-ups that cannot control run-out. Shops without coolant capability or rigid fixturing will not realise the full benefit.
Highlights
- Solid carbide construction resists wear for long tool life
- 90 mm diameter suits precise hole-making tasks
- Twister XD 5X geometry improves chip evacuation
- Designed for power and pneumatic tool compatibility
- California Proposition 65 warning indicates regulated substances present
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Should I choose the 9.90 mm Twister XD 5X or another diameter for my job?
Select the 9.90 mm drill when the hole must be exactly that size; other diameters are separate part numbers and not interchangeable.
What does the 9.90 mm diameter mean once the drill is in the machine?
It produces a 9.90 mm hole in the workpiece when run at the correct speed and feed for the material.
What shank interface does the 2XDSR3898A use and what does it limit?
The solid carbide body uses a straight shank that fits standard drill chucks and collets, limiting use to holders that accept that shank diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
