M.A. Ford
M.A. Ford Twister Xd 3X Solid Carbide Drill 19.25Mm 2XDSS7579A
A 19.25 mm solid carbide drill built for high-performance drilling applications
- Twister Xd design enables 3X faster drilling in tough materials
- Solid carbide construction resists wear for extended tool life
- 25 mm diameter suits precise hole-making tasks
- M.A. Ford engineering delivers reliable performance in power tool applications
- California Proposition 65 warning informs users of chemical exposure risks
Purpose-built drill for 19.25 mm holes
The M.A. Ford Twister Xd 3X is a solid carbide drill sized at 19.25 mm. It targets machinists and maintenance teams who need a single, rigid tool for producing accurate holes in tough materials without swapping inserts.
Replaces indexable or HSS drills in repeat jobs
The solid carbide body removes the need for separate inserts and outperforms high-speed steel when cycle time and hole quality matter. The step up is justified when volumes are high enough to offset the higher tool cost and when the machine spindle can run the speeds carbide demands.
Carbide brittleness limits interrupted cuts
Solid carbide fractures under heavy interruption, deep cross-holes or unstable fixturing. The 3× diameter flute length restricts reach to shallow depths. Proposition 65 warnings note the presence of listed chemicals, so appropriate handling controls are required.
Highlights
- Twister Xd design enables 3X faster drilling in tough materials
- Solid carbide construction resists wear for extended tool life
- 25 mm diameter suits precise hole-making tasks
- M.A. Ford engineering delivers reliable performance in power tool applications
- California Proposition 65 warning informs users of chemical exposure risks
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size does the 19.25 mm Twister Xd drill need to fit my chuck?
The 19.25 mm diameter refers to the cutting portion; the shank is sized to match standard collets or chucks for that drill diameter.
How do I install this solid carbide drill without cracking the tip?
Clamp the workpiece rigidly, use a holder with minimal run-out, and start at low feed before ramping to full speed.
When should I replace the 2XDSS7579A drill?
Replace it when flank wear reaches the supplier’s limit, when hole size drifts out of tolerance, or if the cutting edges chip.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
