M.A. Ford
M.A. Ford Twister Xd 3X Coolant Fed Drill 7.90 mm 2XDCS3110A
A 7.90 mm coolant-fed drill designed for three-times diameter drilling depth
- Twister Xd design enables 3× faster drilling with coolant feed
- 90 mm diameter suits precise hole-making tasks
- Coolant-fed operation reduces heat buildup during extended use
- M.A. Ford manufacturing ensures professional-grade durability
- California Proposition 65 warning informs safe handling practices
Twister Xd 3X Coolant Fed Drill 7.90 mm
This M.A. Ford Twister Xd 3X Coolant Fed Drill measures 7.90 mm in diameter. It is designed for drilling operations where through-tool coolant delivery is required. The tool suits workshops and production lines that need consistent hole quality in metal.
For coolant-fed drilling setups only
This drill suits users with machines that supply coolant through the spindle. It is not for buyers who need a standard twist drill for dry machining or hand-held use. Shops without through-coolant capability should look at a different tool.
7.90 mm diameter decides fit
The 7.90 mm cutting diameter is the critical specification for matching this drill to the required hole size. Verify the diameter against your drawing or tolerance requirements before ordering. The 3X designation indicates the length-to-diameter ratio for depth planning.
Highlights
- Twister Xd design enables 3× faster drilling with coolant feed
- 90 mm diameter suits precise hole-making tasks
- Coolant-fed operation reduces heat buildup during extended use
- M.A. Ford manufacturing ensures professional-grade durability
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 7.90 mm Twister Xd drill in a coolant-fed holder, and what step is often missed?
Mount the shank fully into the holder, align the internal coolant channel with the spindle port, then torque the clamping nut to spec; the step most often missed is verifying coolant flows through the drill before starting the cut.
What maintenance or replacement will the 2XDCS3110A drill need over time?
The cutting edges will dull with use; plan to regrind or replace the drill once flank wear reaches the manufacturer’s limit, and inspect the coolant holes for blockage at each tool change.
What limit appears first on the Twister Xd 3X drill during sustained drilling?
Heat buildup at the cutting lips typically limits continuous run time; if coolant flow drops or chip evacuation slows, the drill will overheat before the shank or holder reaches its mechanical limit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
