M.A. Ford
M.A. Ford Twister XD 3X Coolant Fed Drill 3.50 mm
A 3.50 mm coolant-fed drill bit designed for efficient chip removal during deep-hole drilling
- 3X coolant-fed design clears chips efficiently for deeper holes
- 50 mm diameter suits precise drilling tasks
- Twister XD geometry enhances cutting performance in tough materials
- M.A. Ford manufacturing ensures professional-grade tool reliability
- California Proposition 65 compliance informs safe handling practices
Twister XD 3X Coolant Fed Drill 3.50 mm
The M.A. Ford Twister XD 3X Coolant Fed Drill is a 3.50 mm solid-carbide tool designed for high-performance drilling in demanding materials. Its internal coolant channels deliver fluid directly to the cutting zone for improved chip evacuation and temperature control. This drill targets professional machinists and CNC operators who require reliable hole-making in tough alloys.
Suited for high-volume production
The coolant-fed design suits shops running deep-hole or high-speed cycles where heat buildup and chip packing cause premature wear. It is not intended for hand-held use or machines without through-spindle coolant capability. Buyers needing larger diameters or non-coolant geometries should look at alternative series.
3.50 mm cutting diameter
The 3.50 mm diameter is the critical specification that determines fit for a specific hole size. Verify this exact dimension against your drawing or tooling plan before ordering. The 3X designation indicates a length-to-diameter ratio optimised for moderate-depth holes. California Proposition 65 warnings apply to this product.
Highlights
- 3X coolant-fed design clears chips efficiently for deeper holes
- 50 mm diameter suits precise drilling tasks
- Twister XD geometry enhances cutting performance in tough materials
- M.A. Ford manufacturing ensures professional-grade tool reliability
- California Proposition 65 compliance informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 3.50 mm Twister XD 3X drill need to fit my collet?
The drill is 3.50 mm in diameter, so it requires a 3.50 mm collet or chuck capacity for a secure fit.
How do I correctly install the coolant-fed drill so the internal channels align?
Insert the drill fully into the holder until the shank seats, then engage the machine's coolant supply to pressurise the through-tool channels before cutting.
When should I replace the Twister XD 3X drill based on wear?
Replace the drill when the cutting edges show visible rounding, the margin width narrows, or hole size drifts beyond tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
