M.A. Ford
M.A. Ford Twister Xd 3X Coolant Fed Drill 11.80 mm
Coolant-fed drill bit with 11.80 mm diameter for efficient metal drilling
- Coolant-fed design clears chips efficiently during deep drilling
- 3X diameter capability handles deeper holes in a single pass
- 80 mm cutting diameter matches precise hole requirements
- M.A. Ford construction delivers professional-grade durability
- California Proposition 65 compliance noted for regulated environments
Professional Drilling Application
The M.A. Ford Twister Xd 3X is a coolant-fed drill built for production environments that demand repeatable hole quality. Its 11.80 mm cutting diameter suits manufacturers and machine shops running high-volume metalwork where consistent chip evacuation and tool life are critical.
Thermal Management And Power Draw
Internal coolant channels deliver fluid directly to the cutting zone, controlling heat buildup during extended cycles. This reduces thermal expansion in the workpiece and lowers the cutting forces that drive spindle load, keeping power consumption steady across long runs.
11.80 Millimetre Diameter
The single specification that decides fit is the 11.80 mm drill diameter; the tool only produces holes of this exact size. Shops needing a different bore must select another diameter from the range.
Highlights
- Coolant-fed design clears chips efficiently during deep drilling
- 3X diameter capability handles deeper holes in a single pass
- 80 mm cutting diameter matches precise hole requirements
- M.A. Ford construction delivers professional-grade durability
- California Proposition 65 compliance noted for regulated environments
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 11.80 mm Twister Xd 3X Coolant Fed Drill and what step is often missed?
Mount the drill in a compatible coolant-fed holder, align the 11.80 mm shank precisely, then connect the coolant supply before starting; operators often forget to purge air from the coolant line first.
What maintenance or replacement will the 2XDCS4646A drill need later?
Inspect the cutting edges after each job; resharpen or replace the drill when flank wear reaches the manufacturer’s limit, and clean coolant passages to prevent blockage.
What limit appears first on the 11.80 mm Twister Xd drill under sustained use?
Heat buildup at the cutting zone is the first constraint; without adequate coolant flow the drill will overheat and lose hardness before other wear modes develop.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
