M.A. Ford
M.A. Ford Twister GP 5X Drill Straight Shank No 45 Part 30008200
A straight-shank twist drill, size No 45, designed for general-purpose drilling
- M.A. Ford brand trusted by professionals for reliable performance
- Twister GP 5X design engineered for efficient drilling
- Straight shank ensures secure fit in standard chucks
- No 45 size ready for immediate use
- Part 30008200 identifies exact replacement component
M.A. Ford Twister GP 5X Drill No 45
The M.A. Ford Twister GP 5X Drill Straight Shank No 45 is a precision cutting tool built for production drilling. It carries part number 30008200 and arrives in new condition. The design targets consistent hole quality in demanding metalworking tasks.
Suited for high-feed 5×D operations.
Shops running deep-hole cycles at elevated feed rates will match the geometry to their process. The straight shank fits standard holders without adapters. Buyers who need a shorter flute length or a different point angle should look at another tool.
California Proposition 65 chemical notice applies
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. The warning is required under Proposition 65. Handle with appropriate personal protective equipment and follow shop safety procedures.
Highlights
- M.A. Ford brand trusted by professionals for reliable performance
- Twister GP 5X design engineered for efficient drilling
- Straight shank ensures secure fit in standard chucks
- No 45 size ready for immediate use
- Part 30008200 identifies exact replacement component
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck is required to hold the No 45 shank?
The straight shank fits any standard chuck that accepts a No 45 diameter bit.
Will the Twister GP 5X drill produce the same hole quality in a worn drill press as in a new one?
The drill geometry is unchanged; hole quality depends on spindle run-out and rigidity of the press you keep.
How can I verify the 30008200 drill is cutting correctly after the first hole?
Check for a clean, round hole with consistent chip evacuation and no discolouration on the cutting edges.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
