M.A. Ford
M.A. Ford Twister GP 5X Drill Straight Shank No 18 30016950
A size 18 Twister GP 5X drill bit with a straight shank for general-purpose drilling
- Twister GP 5X geometry enables 5× faster drilling
- Straight shank design fits standard drill chucks securely
- Size No 18 suits precise hole-making tasks
- California Proposition 65 warning informs safe handling
- Brand M.A. Ford backs professional-grade tool quality
M.A. Ford Twister GP 5X Drill No 18
The M.A. Ford Twister GP 5X drill is a straight shank cutting tool sized at No 18 for general-purpose holemaking. It suits maintenance technicians and machinists who need a reliable drill for everyday metalworking tasks. The product arrives new and carries the manufacturer part number 30016950.
Replaces worn or undersized straight shank drills
Switching to this drill is worthwhile when an existing bit has dulled, chipped or no longer matches the required No 18 diameter. The upgrade restores consistent cutting performance in steel and similar materials. Buyers who need a different diameter or a tapered shank will not be served by this item.
Straight shank fits standard drill chucks
Installation consists of clamping the straight shank into a compatible drill chuck or collet, requiring no special adapters. Problems usually arise if the chuck is worn, undersized or overtightened, which can cause runout or shank damage. California Proposition 65 warnings note the presence of chemicals linked to cancer and reproductive harm.
Highlights
- Twister GP 5X geometry enables 5× faster drilling
- Straight shank design fits standard drill chucks securely
- Size No 18 suits precise hole-making tasks
- California Proposition 65 warning informs safe handling
- Brand M.A. Ford backs professional-grade tool quality
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What drill chuck size does the No 18 straight shank require?
The No 18 straight shank fits a standard drill chuck that accepts its diameter; tighten the chuck fully on the flat sections to prevent slipping during use.
How should the Twister GP 5X drill be installed in the chuck to avoid run-out?
Insert the straight shank fully, align the flats with the chuck jaws, and tighten each jaw evenly; the step most users miss is re-checking tightness after the first few seconds of drilling.
When does the Twister GP 5X drill need to be replaced?
Replace the drill when the cutting lips show visible wear, the point angle is no longer sharp, or the tool produces excessive heat and poor hole finish in the material being drilled.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
