M.A. Ford
M.A. Ford Twister GP 5X 30010940 Straight Shank Drill 7/64
Straight-shank drill bit in 7/64 inch size for general-purpose drilling
- Precision drilling with Twister GP 5X geometry
- Straight shank design fits standard chucks securely
- 7/64 inch diameter for specific hole sizes
- M.A. Ford quality for reliable performance
- California Proposition 65 chemical warning applies
M.A. Ford Twister GP 5X 7/64 drill
The M.A. Ford Twister GP 5X 30010940 is a straight shank drill bit sized at 7/64. It is manufactured by M.A. Ford for general purpose drilling tasks in a workshop or job site setting. The item is supplied new and ships directly from the manufacturer. California Proposition 65 warnings apply to this product regarding cancer and reproductive harm.
Suitable for general drilling needs
This drill bit suits users who require a 7/64 straight shank tool for standard drilling applications. It is not intended for buyers who need a different diameter, a reduced shank, or a specialised coating for high-performance alloys. Shoppers looking for a complete drill set or a different point geometry should consider other options.
Verify shank compatibility before ordering
Check that your drill chuck accepts a straight shank of this diameter before purchase. Confirm the 7/64 size matches the hole requirement for your specific fastener or pilot hole. Ensure your workspace complies with California Proposition 65 handling guidelines for the listed chemical warnings.
Highlights
- Precision drilling with Twister GP 5X geometry
- Straight shank design fits standard chucks securely
- 7/64 inch diameter for specific hole sizes
- M.A. Ford quality for reliable performance
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size do I need to hold the 7/64 straight shank?
A standard 1/4-inch or 3/8-inch drill chuck will grip the 7/64 straight shank securely for use.
Can I run this Twister GP 5X drill in a cordless drill that only has a 1/4-inch hex quick-change chuck?
No, the straight round shank requires a three-jaw chuck; a hex-only quick-change chuck cannot hold it.
How do I confirm the drill is cutting correctly after I start the hole?
The drill should produce clean, curled chips and advance smoothly without excessive heat or wandering.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
