M.A. Ford
M.A. Ford Twister GP 3X Drill 9.10 mm 22635820
A 9.10 mm Twister GP 3X drill bit for high-efficiency drilling applications
- Precision drilling with 9.10 mm diameter
- M.A. Ford quality for reliable performance
- Twister GP 3X design for efficient material removal
- California Prop 65 compliance disclosed
- New condition ready for immediate use
Drill for general-purpose machining
The M.A. Ford Twister GP 3X Drill 9.10 mm 22635820 is a new cutting tool built for general-purpose drilling tasks. It serves machinists and maintenance teams who need a reliable 9.10 mm diameter drill for everyday workshop use. The design targets consistent hole quality across a range of common materials.
Step up from standard jobber drills
This 3X geometry replaces basic jobber-style drills when faster penetration and longer tool life are required. The upgrade makes sense for shops running higher volumes or tougher alloys where standard drills wear quickly or wander on entry. It is not suited for deep-hole applications beyond the 3X length ratio or for highly specialised materials needing dedicated geometry.
Steady cutting under sustained load
The drill maintains stable cutting forces during extended drilling cycles rather than only in short bursts. Its construction resists heat buildup and edge chipping when run continuously in production environments. Operators can expect consistent chip evacuation and diameter accuracy throughout the tool's service life.
Highlights
- Precision drilling with 9.10 mm diameter
- M.A. Ford quality for reliable performance
- Twister GP 3X design for efficient material removal
- California Prop 65 compliance disclosed
- New condition ready for immediate use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size fits the 9.10 mm shank of the Twister GP 3X Drill 22635820?
The 9.10 mm shank requires a chuck that accepts at least 9.10 mm; a 10 mm or 3/8 inch chuck will hold it securely.
How do I install the Twister GP 3X Drill 22635820 without snapping the tip?
Insert the bit fully, tighten the chuck evenly, start the drill at low speed with steady pressure, and let the cutting edges engage before increasing RPM.
When should I replace the Twister GP 3X Drill 22635820?
Replace it when the cutting lips are chipped, the margins are worn, or the drill walks and produces excessive heat in the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
