M.A. Ford
M.A. Ford Twister Gp 3X Drill 4.40mm 22617320
4.40 mm Twister Gp 3X drill bit for high-performance drilling applications
- Twister Gp 3X geometry drills faster holes
- 40 mm diameter suits precise drilling tasks
- M.A. Ford brand trusted by professionals
- California Proposition 65 warning informs safe handling
- Manufacturer part 22617320 ensures correct identification
M.A. Ford Twister Gp 3X Drill 4.40mm
The M.A. Ford Twister Gp 3X Drill is a new power tool accessory manufactured to a 4.40 mm diameter. It carries the manufacturer part number 22617320 and is supplied directly by M.A. Ford. This drill bit suits workshops needing a precise 4.40 mm cutting tool for general drilling tasks.
California Proposition 65 compliance
The product bears California Proposition 65 warnings for chemicals known to cause cancer and birth defects or other reproductive harm. Orders valued at 75 or more qualify for free shipping from the manufacturer. These notices and terms affect daily handling and procurement planning for the workshop.
Verify drill diameter and regulatory requirements
Before ordering confirm that a 4.40 mm drill matches the hole size required by your application. Ensure your operation can accommodate the Proposition 65 warnings regarding chemical exposure. Check that the 75 threshold for free shipping aligns with your purchasing volume.
Highlights
- Twister Gp 3X geometry drills faster holes
- 40 mm diameter suits precise drilling tasks
- M.A. Ford brand trusted by professionals
- California Proposition 65 warning informs safe handling
- Manufacturer part 22617320 ensures correct identification
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What drill-point standard does the 4.40 mm Twister GP 3X use, and what material hardness does it limit?
The drill follows the Twister GP 3X geometry for general-purpose drilling; the 4.40 mm diameter caps the maximum hole size in steel up to typical tensile limits for this series.
What shank style and diameter does the 4.40 mm Twister GP 3X require for a secure chuck fit?
It has a straight 4.40 mm shank matching the drill diameter, so a standard three-jaw chuck or collet that closes to 4.40 mm holds it without an adapter.
How do you install the 4.40 mm Twister GP 3X in a drill press, and what step is often missed?
Open the chuck fully, insert the shank until the flutes clear the jaws, tighten evenly on all three jaws, then verify the drill runs true before applying feed pressure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
