M.A. Ford
M.A. Ford Twister Brad And Spur Drill No 17 pneumatic accessory
Twister Brad and Spur Drill No 17 creates clean starter holes for wood screws in pneumatic drills
- Twister design drills clean brad-point holes
- Spur cutting edges reduce splintering in wood
- Number 17 size suits precise joinery tasks
- M.A. Ford quality built for pneumatic power tools
- California Proposition 65 chemical warning applies
Product identity
The M.A. Ford Twister Brad And Spur Drill No 17 is a pneumatic accessory designed for precision drilling tasks in automotive and workshop environments. It suits technicians who need a dedicated brad-and-spur bit for clean hole starts in wood or composite materials.
Compatibility check
Verify that your pneumatic drill or driver accepts the No 17 shank configuration before ordering. Confirm the tool’s chuck capacity and air-pressure rating match the accessory’s requirements to avoid fitment or performance issues.
Sustained-load behaviour
Under continuous use the bit maintains cutting geometry without rapid dulling, reducing the need for frequent changes during extended drilling sessions. The design resists heat build-up so accuracy holds over longer runs rather than only in short bursts.
Highlights
- Twister design drills clean brad-point holes
- Spur cutting edges reduce splintering in wood
- Number 17 size suits precise joinery tasks
- M.A. Ford quality built for pneumatic power tools
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What is included with the Twister Brad And Spur Drill No 17 and what else must be purchased separately?
The package contains the No 17 drill bit only; a compatible pneumatic drill motor and air supply must be supplied by the user.
How do I choose the correct version of the Twister Brad And Spur Drill?
The model number 20717300 identifies the No 17 size; select this exact part number to match the required hole diameter.
What does the No 17 designation mean when the bit is used in a pneumatic drill?
No 17 specifies the drill-bit diameter, so the tool will cut a hole of that size in the workpiece when driven by compressed air.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
