M.A. Ford
M.A. Ford Twister Brad and Spur Drill 11.00 mm 20743310
Drills clean 11.00 mm holes with brad and spur tip for accurate wood boring
- 00 mm diameter drills precise holes in wood
- Brad point tip centres the bit without wandering
- Spur cutters shear fibres for clean edges
- Twister flute design clears chips efficiently
- M.A. Ford 20743310 built for professional results
11.00 mm Brad and Spur Drill
The M.A. Ford Twister Brad and Spur Drill is a precision cutting tool designed for clean, accurate holes in wood and similar materials. Its 11.00 mm diameter suits joinery, cabinetry and general woodworking tasks where a flat-bottomed bore is required. The brad point centres the drill without wandering, while the spur cuts the perimeter fibres for a splinter-free edge. This accessory fits standard drill chucks used by professional woodworkers and serious hobbyists.
Sustained drilling performance
Under continuous use the high-speed steel construction resists heat build-up, allowing the cutting edges to stay sharp through repeated holes. The flute geometry clears chips efficiently, reducing binding and motor strain during deep bores. Consistent feed pressure produces uniform holes without burn marks, even when drilling multiple pieces in succession. The tool maintains its geometry over extended sessions, minimising the need for frequent resharpening.
Compatibility and safety checks
Verify that your drill chuck accepts an 11.00 mm shank and that the machine delivers sufficient torque for the material thickness. Ensure the workpiece is clamped securely to prevent rotation during breakthrough. The product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm, so wear appropriate respiratory and skin protection when machining. Confirm the drill’s maximum speed rating matches the manufacturer’s recommendation for this diameter.
Highlights
- 00 mm diameter drills precise holes in wood
- Brad point tip centres the bit without wandering
- Spur cutters shear fibres for clean edges
- Twister flute design clears chips efficiently
- M.A. Ford 20743310 built for professional results
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 11.00 mm drill bit generate noticeable heat during extended drilling sessions?
The 11.00 mm Twister Brad and Spur Drill is designed for efficient chip removal, which helps manage heat build-up during prolonged use in wood materials.
What type of drill chuck is required to hold the 20743310 bit securely?
The bit uses a standard round shank compatible with keyed or keyless drill chucks that accept an 11.00 mm diameter.
Will the M.A. Ford 20743310 work effectively in older drill presses with lower RPM ranges?
Yes, the brad point and spur design cuts cleanly at lower speeds typical of older drill presses, reducing tear-out in wood.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
